408-7984 Datasheet, PDF (1/1 Pages) TE Connectivity Ltd – Reasons for reissue of this instruction sheet are provided in Section 6, REVISION SUMMARY.



Insertion Tool 455830-1
Pin Contact
Connector
Instruction Sheet
408-7984
12 DEC 11 Rev A
Socket Contact
Connector
Note: Not to Scale
4.83 mm [19 in.]
Contact Cavity
6.35 mm [.25 in.]
76.2 mm [3.00 in.]
38.1 mm [1.50 in.]
Locking
Lance
Contact
Insulation
Barrel
Tool Insertion Tips
Tool
Handles
Wire
Figure 1
1. INTRODUCTION
Insertion Tool 455830-1 is designed to insert a
Universal MATE-N-LOK* pin or socket contact into a
connector housing. See Figure 1. Read these
instructions thoroughly before using the tool.
NOTE
i
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
Figures are not drawn to scale.
3. Remove the insertion tips from the contact cavity,
then pull back lightly on the wire of the contact to
make sure that the contact is locked in place.
4. TOOL INSPECTION
It is recommended that the insertion tool be inspected
immediately upon arrival and at regularly scheduled
intervals to ensure that the tool has not been
damaged. The insertion tool should be inspected
using the dimensions provided in Figure 1.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
2. DESCRIPTION
This tweezer-shaped insertion tool features two
grooved insertion tips for grasping the wire of the
contact to be inserted and two tool handles, which
assist in applying even pressure to the insertion tips.
3. INSERTION PROCEDURE (See Figure 1)
1. Place the insertion tool over the wire with the
insertion tips behind the contact insulation barrel.
2. Insert the contact into the contact cavity of the
housing until the locking lance of the contact is fully
seated.
5. REPLACEMENT
Insertion tools can be purchased from:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
6. REVISION SUMMARY
Revisions to this instruction sheet include:
• Changed company name and logo
• Changed address in Section 5
©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change.
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
*Trademark
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 1
LOC B