408-7276 Datasheet, PDF (1/1 Pages) TE Connectivity Ltd – Remove the contact by pulling it out of the rear of cavity.


Extraction Tool 91019-3
for Type XII Contacts
Instruction Sheet
408-7276
23 JAN 12 Rev C
Wire Lead
Tool Tip
Tip
Male Contact
Handle
Housing
Tip
Offsets in Cavity
Figure 1
1. INTRODUCTION
This tool (see Figure 1) is used to extract Type XlI (male
and female) Contacts from their housings. A list of the
contacts is shown in the table in Figure 2.
Read these instructions carefully before using the tool.
CONTACT NUMBER
FEMALE CONTACT
MALE CONTACT
66258
(66252 LP)
66261 (66255 LP)
66262 (66256 LP)
66329 (66330 LP)
66257
66251 LP)
66259 (66253 LP)
66260 (66254 LP)
66326 (66327 LP)
Figure 2
2. DESCRITION
The tool consists of a sectionalized handle (see 
Figure 1) and two tooling tips.
Figure 3
5. Remove the contact by pulling it out of the rear of
cavity.
3.2. Extraction of Female Contact
1. Insert the tool tips into the offsets in the cavity. See 
Figure 4 .
2. Push the tool into the housing until it bottoms in the
cavity.
NOTE
i
The rear section of the handle will back out of the
tool.
3. Keeping the tool bottomed in the cavity, push the
rear section of thehandle toward thehousing.
4. Remove the contact by pulling it out of rear of the
cavity.
Wire Lead
Cavity
3. EXTRACTION
3.1. Exraction of Male Contact
1. Pull the rear section of handle back.
2. Keeping sections of handle separated, slide tool tips
over male contact and into offsets in cavity. See
Figure 3.
3. Push the tips of the tool into the housing until they
bottom in the cavity.
4. Keeping the tool bottomed in the cavity, push the
rear section of the handle toward the housing.
Housing
Tool Tips
Figure 4
4. REVISION SUMMARY
Revisions to this instruction sheet include:
• Changed company name and logo
• Revised title error
©2012 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change.
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
*Trademark
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 1
LOC B