408-7158 Datasheet, PDF(1/2 Page) TE Connectivity Ltd

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

408-7158 Datasheet, PDF (1/2 Pages) TE Connectivity Ltd – Extraction Tools

Extraction Tools 1-305183-1 and

1-305183-2 for MATE-N-LOK* Contacts

Socket Extraction

Tool 1-305183-2

Instruction Sheet

408-7158

22 APR 15 Rev A

Sleeve

Handle

Pin Extraction Tool

1-305183-1

Push Rod Button

Figure 1

1. INTRODUCTION

Extraction Tools 1-305183-1 and 1-305183-2 are designed to remove contacts from MATE-N-LOK connectors.

Tool 1-305183-1 is used for the pin contacts, and tool 1-305183-2 for the socket contacts. Read these

instructions thoroughly before starting.

NOTE

Dimensions in this instruction sheet are in millimeters [with inches in brackets]. Figures and illustrations are for reference only

and are not drawn to scale.

Refer to Section 5, REVISION SUMMARY for reason for reissue.

2. DESCRIPTION

Both tools feature a handle and sleeve assembly to release the contact locking lance, and a push rod button to

eject the contact.

3. EXTRACTION PROCEDURE

Select the appropriate extraction tool, according to the type of contact (pin or socket) to be removed (see

Figure 1).

Pin and Socket Extraction (Figure 2)

1. Push in and hold firmly on wire of contact to be removed. This will disengage locking lance from

groove in connector.

2. Grasp the tool handle, and place sleeve over end of contact. Rotating tool slightly, push sleeve

straight into cavity until it bottoms. Allow push rod button to âback outâ of handle. The locking lance is

now released.

3. Keep sleeve firmly bottomed in cavity, and depress push rod button. Contact will partially eject as

push rod button is depressed.

4. Pull contact from REAR of connector, and remove tool from cavity.

4. TOOL CERTIFICATION

The extraction tools listed on this document should be certified with the information provided in Figure 3.

TE Connectivity recommends that each tool be inspected immediately upon arrival in your factory, and at

regularly scheduled intervals, to ensure that the tool has not been damaged during handling. Additional tools

can be purchased from TE.

*Trademark

TOOLING ASSISTANCE CENTER 1-800-722-1111

PRODUCT INFORMATION 1-800-522-6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.te.com.

TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.

1 of 2

▷