408-6877 Datasheet, PDF(1/5 Page) TE Connectivity Ltd

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

408-6877 Datasheet, PDF (1/5 Pages) TE Connectivity Ltd – Crimping Die Assemblies

Crimping Die Assemblies

58085-1, 58086-1, and 58174-1

Instruction Sheet

408-6877

07 NOV 14 Rev C

PROPER USE GUIDELINES

Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low

volume applications. A wide selection of powered application equipment for extended-use, production operations is available.

Die Retaining

Screws

Stationary Jaw

Indenter Die

Crimping Die

Assembly

58085-1 (Ref)

PRO-CRIMPER* III

Frame Assembly

354940-1 (Ref)

Anvil Die

Center Contact

Crimping Chamber

Movable

Jaw

Ferrule Crimping

Chamber

DIE ASSEMBLY

PART NO.

58085-1

58086-1, 58174-1

CONNECTOR BASE

PART NO.

221185, 221199, 221221, 221402

221185, 221199, 221221

Figure 1

1. INTRODUCTION

This instruction sheet covers the use and maintenance of Crimping Die Assemblies 58085-1, 58086-1, and

58174-1, which are used to crimp 75-Ohm RF Series BNC Dual Crimp Connectors. The die assemblies are

designed to be used in PRO-CRIMPER III Frame Assembly 354940-1.

Refer to Figure 1 for a list of connectors that are compatible with the die assemblies. For additional connector

part number information, refer to the PRODUCT INFORMATION number listed at the bottom of this page. For

instructions concerning the operation of the tool frame, refer to Instruction Sheet 408-9930. Read these

instructions thoroughly before using the die assemblies.

NOTE

All dimensions are in millimeters [with inch equivalents in brackets]. Figures and illustrations are for identification only, and are

not drawn to scale.

Reasons for reissue are provided in Section 8, REVISION SUMMARY.

2. DESCRIPTION (Figure 1)

Each die assembly consists of an indenter and an anvil, both of which contain two crimping chambers. The

small crimping chamber produces a box crimp on the center contact of the connector, and the other crimping

chamber crimps the connector ferrule. Each die is held in the tool frame by a single screw.

3. DIE INSTALLATION

1. Slide the die assembly into the partially-opened tool jaws. The anvil die must be installed in the

movable jaw of the tool and the indenter in the stationary jaw. The center contact crimping chamber

must be toward the front of the tool as shown in Figure 1.

2. Insert, but do not completely tighten, the die retaining screws.

*Trademark

TOOLING ASSISTANCE CENTER 1-800-722-1111

PRODUCT INFORMATION 1-800-522-6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.te.com.

TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.

1 of 5

▷