408-4452 Datasheet, PDF (1/4 Pages) TE Connectivity Ltd – PRO-CRIMPER III Hand Crimping

PRO- CRIMPER* III Hand Crimping
Tool Assembly 58628- 1 with
Die Assembly 58628- 2
Instruction Sheet
408- 4452
29 APR 11 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Front of Tool
Die Assembly
Moving Jaw
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
PRO- CRIMPER III Hand
Crimping Tool Frame
354940- 1 (408- 9930)
Ratchet Adjustment
Wheel
The PRO- CRIMPER III Hand Crimping Tool Assembly is a “Commercial”
grade tool and is designed primarily for field installation, repair, maintenance
work, or prototyping in industrial, commercial, or institutional applications.
Product crimped with this tool will meet the crimp height requirement for hand
tools in the appropriate 114 series specification, but may not comply with other
feature parameters of the specification. TE Connectivity offers a variety of tools
to satisfy your performance requirements. For additional information, contact
the Tooling Assistance Center at 1- 800- 722- 1111.
Stationary
Handle
Moving
Handle
Wire
TE Die
Assembly
Product
Family}
Size
(AWG)
Insulation Diameter (Max) (mm [in.])
for Receptacle Series Size
110 and 125
187 and 250
Standard
Large
Standard Large
58628--2
Ultra--Fast FASTON*
Straight Receptacle
26--22
22--18
16--14
2.54 [.100]
3.05 [.120]
—
—
5.84 [.230]
6.60 [.260]
—
3.43 [.135]
4.06 [.160]
—
5.84 [.230]
6.60 [.260]
} Contact the Tooling Assistance Center or Product Information (at the numbers listed below) for specific receptacle part numbers.
Figure 1
Strip Length
(mm [in.])
7.14+0.41
[.281+.016]
1. INTRODUCTION
PRO--CRIMPER III Hand Crimping Tool Assembly
58628--1 consists of Die Assembly 58628--2 and
PRO--CRIMPER III Hand Crimping Tool Frame
354940--1. The tool is used to crimp the receptacles
onto the wire sizes listed in Figure 1.
Read these instructions thoroughly before crimping
any receptacles.
If these instructions are revised, reasons for revison
will be listed in Section 9, REVISION SUMMARY.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
are for identification only and are not drawn to
scale.
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1--800--722--1111 This controlled document is subject to change.
PRODUCT INFORMATION 1--800--522--6752
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 4
LOC B