408-4430 Datasheet, PDF (1/3 Pages) TE Connectivity Ltd – Read these instructions and understand them before using the seating tool and support anvil.

Seating Tools 318868-1, 91326-1, and 91327-1 and
Support Anvil 318867-1 for Z-PACK Hard Metric (HM)
2mm Integral Upper Ground Return Shields
Instruction Sheet
408-4430
19 OCT 11 Rev C
ACTION PIN* Contact
(with PC Board
Retention Feature)
Seating Tool
(318868-1 Shown)
Upper Ground Return
Shield (Ref)
Printed Circuit (PC) Board (Ref)
Support Anvil
PC Board Support Fixture (Ref)
(679980-[ ] Recommended)
Figure 1
1. INTRODUCTION
Seating Tools 318868-1, 91326-1, and 91327-1 and
Support Anvil 318867-1 are used to seat upper ground
return shields onto Z-PACK HM 2mm receptacles and
right-angle receptacles with integral upper ground
return shields onto printed circuit (pc) boards. The
shields and receptacles with integral shields contain
ACTION PIN contacts to allow solderless pc board
installation. See Figure 1.
NOTE
i
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
Figures are not drawn to scale.
Read these instructions and understand them before
using the seating tool and support anvil.
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
2. DESCRIPTION
The seating tool and support anvil are each a one-piece
design.
The support anvil is positioned into a pc board support
fixture to support the pc board. During seating, the
seating tool covers the shield and receptacle and
presses on the top surface of the shield when the
applicator ram applies force.
3. REQUIREMENTS
3.1. PC Board Support Fixture (Customer Supplied)
A pc board support must be used to provide proper
support for the pc board and to protect the pc board
and header assembly from damage. PC Board
Support Fixture 679980-[ ] is recommended for use
with this seating tool and support anvil. For proper
selection and detailed information, refer to instruction
sheet 408-4038. Or, design a pc board support fixture
using the recommendations in 408-6927.
©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change.
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
*Trademark
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 3
LOC B