408-4374 Datasheet, PDF(1/2 Page) TE Connectivity Ltd

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

408-4374 Datasheet, PDF (1/2 Pages) TE Connectivity Ltd – Extraction Tools

Extraction Tools

318813-1 and 318813-3

Interlock Lever

Plastic Handle

Instruction Sheet

408-4374

16 FEB 15 Rev B

Spring-Loaded

Metal Tip

Figure 1

1. INTRODUCTION

Extraction Tool 318813-1, shown in Figure 1, is designed to remove the Size 8 straight and right-angle coaxial

contacts and AMPLIMITE* power contacts and .125 POWERBAND* contacts listed in Figure 2 from connector

housings. Read these instructions thoroughly before attempting to remove any contacts. Tool 318813-3 is

designed for the Extended POWERBAND Pin contacts.

CONTACT BASE PART NUMBER

COAXIAL

POWER

228596-1

228604-1

228618-1

211159-1

211159-2

211161-1

211161-2

212007-1

212008-1

212013-1

212014-1

213841-1

213843-1

213845-1

213847-1

Figure 2

2. DESCRIPTION (Figure 1)

The extraction tool consists of a spring-loaded metal tip with an integral plunger mounted to a plastic handle

with an interlock lever. When the interlock lever is depressed, the plunger is held until the contact locking

lances are depressed by the tip.

After the lever is released, the plunger is released, permitting the contact to be pushed out the rear of the

housing.

3. EXTRACTION PROCEDURE (Figure 3)

NOTE

Before extracting coaxial contacts, use a small, sharp tool to remove the nylon alignment ring from the front of the contact.

1. Determine the contact to be removed and grasp the wire attached to that contact.

2. Move the contact forward as far as possible by pushing the wire toward the housing.

3. Depress the extraction tool interlock lever and insert the tip of the tool into the contact cavity in the

mating face of the housing. Make sure that the tip is completely bottomed in the cavity.

4. While holding the tool in position, release the interlock lever, then push the handle until the contact

backs out of the rear of the housing. The wire and contact should pull out of the housing.

*Trademark

TOOLING ASSISTANCE CENTER 1-800-722-1111

PRODUCT INFORMATION 1-800-522-6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.te.com.

TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.

1 of 2

▷