408-4087 Datasheet, PDF (1/5 Pages) TE Connectivity Ltd – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools.

Hand Crimping Tool 607949-1
(For Insulated Heat Shrink Splices)
Instruction Sheet
408-4087
23 JAN 12 Rev C
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Read these instructions thoroughly before crimping
any contacts.
Front of
Tool
Crimper
Jaws
Anvil
Jaws
NOTE
All dimensions on this document are in metric units
[with U.S. customary units in brackets]. Illustrations
i
and figures are for reference only and are not
drawn to scale
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
Ratchet
2. DESCRIPTION
The tool features crimper and anvil jaws, color coded
wire size marking, spring actuated handles with
cushioned hand grips, and a ratchet mechanism which
will not release until the tool handles have been
FULLY closed, thus ensuring a reliable crimp
termination.
NOTE
i
If the ratchet should need adjustment, refer to
Paragraph 4.2.C.
Cushioned
Hand Grips
Figure 1
1. INTRODUCTION
Hand Crimping Tool 607949-1, a three-cavity, two-jaw
crimping tool is designed to crimp the conductor
portion of insulated heat-shrink splices in the following
range of wire sizes:
• RED - Wire sizes 22 to 16 AWG, outer cavity.
• BLUE - Wire sizes 16 to 14 AWG, middle cavity.
• YELLOW - Wire sizes 12 to 10 AWG, inner cavity.
3. CRIMPING PROCEDURES (Figure 2)
1. Close the tool handles until the ratchet releases,
then allow the tool handles to open fully.
2. Select the appropriate cavity for the splice being
crimped.
3. Align conductor portion of terminal in the cavity
as shown in Figure 2.
4. Close the tool carefully until the jaws grip the
terminal lightly and hold it in place without distortion.
5. Insert a properly stripped wire (Figure 2) into the
terminal until it bottoms.
6. To crimp, hold the wire in place, squeeze the
handles until the ratchet releases, allow the jaws to
open FULLY, and remove crimped splice.
4. MAINTENANCE/INSPECTION
4.1. Daily Maintenance
Maintenance and inspection should be performed
regularly. Tool should be wiped clean with special
emphasis on the crimping cavities.
©2012 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B