408-4051 Datasheet, PDF (1/4 Pages) TE Connectivity Ltd – PRO-CRIMPER III Hand Crimping

PRO-CRIMPER* III Hand Crimping
Tool Assembly 58541-1
with Die Assembly 58541-2
Instruction Sheet
408-4051
11 NOV 13 Rev D
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Stationary Jaw
Pivot Pin
Front of Tool
Locator Side)
Die Assembly
Moving Jaw
Back of Tool
(Wire Side)
PRO-CRIMPER III Hand
Crimping Tool Frame
354940-1 (See Instruction
Sheet 408-9930)
Ratchet
Adjustment
Wheel
Moving Handle
Stationary Handle
The PRO-CRIMPER III Hand Crimping Tool Assembly is a “Commercial” grade tool and is designed
primarily for field installation, repair, maintenance work, or prototyping in industrial, commercial, or
institutional applications. Product crimped with this tool will meet the crimp height requirement for hand
tools in the appropriate 114 application specification, but may not comply with other feature parameters
of the specification. TE Connectivity offers a variety of tools to satisfy your performance requirements.
For additional information, contact the Tooling Assistance Center at 1-800-722-1111.
DIE ASSEMBLY
PART NUMBER
LOCATOR
ASEMBLY PART
NUMBER†
CONTACT
FAMILY‡
SIZE
(AWG)
WIRE
INSULATION
DIAMETER
(mm [in.])
STRIP LENGTH
(mm [in.])
58541-2
189382-1
67 MULTIMATE*
Type II Series
Contacts
24-20
18-14
1.40 to 2.16
[.055 to .085]
Open
5.32
[.209]
6.35
[.250]
† Supplied with the die assembly. Also available separately. ‡Contact the Product Information Center (below) for specific contact part numbers.
Figure 1
1. INTRODUCTION
PRO-CRIMPER III Hand Crimping Tool Assembly
58541-1 consists of Die Assembly 58541-2 and
PRO-CRIMPER III Hand Crimping Tool Frame
354940-1. The die assembly consists of crimping dies
and a locator assembly. Refer to Figure 1.
Read these instructions thoroughly before crimping
any contacts.
iNOTE NOTE
Dimensions on this sheet are in millimeters [with inch
equivalents provided in brackets]. Figures and
illustrations are for identification only and are not drawn
to scale.
©2013 Tyco Electronics Corporation, a TE Connectivity Ltd. company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or company names may be trademarks of their respective owners.
1 of 4