408-32083 Datasheet, PDF (1/4 Pages) TE Connectivity Ltd – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools

SDE-SA Commercial Hand
Tool 2217268-[ ]
for PTL Connectors
Instruction Sheet
408-32083
10 DEC 12 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locking Nut
Locator
Insulation Crimper
(Upper Die)
Wire Crimper
(Upper Die)
Stationary
Jaw
Moving
Jaw
Handle
Emergency
Ratchet
Release
Die Retaining
Screws _{Pins (4)}
Anvil (Lower)
Wire Die
Die Set
2217268-2
Anvil (Lower)
Insulation Die
Ratchet
Adjustment
Wheel
CRIMP TOOLING
SDE-SA
TOOL
DIE
ASSEMBLY
2217268-1
2217268-2
PTL
TERMINAL
1971779-1
1971779-2
1971780-1
1971780-2
CABLE
WIRE SIZE
mm² [in.]
NUMBER OF
CONDUCTORS
3.30 [12]
1
WIRE INSULATION mm [in.]
DIAMETER
STRIP
LENGTH
3.85-4.25
[.152-.167]
4.5 ±0.3
[.177 ±.012]
Figure 1
1. INTRODUCTION
SDE-SA Commercial Hand Tool Assembly 2217268-[ ]
for the PTL (Power Triple Lock) connectors consists of
the tool and die set shown in Figure 1. The tool
consists of the of SDE-SA Frame Assembly
9-1478240-0 (Instruction Sheet 408-8851) and die
assembly listed in Figure 1. This tool is used to crimp
the terminal numbers provided in the table in Figure 1.
iNOTE NOTE
Dimensions in this instruction sheet are in millimeters
with [inches in brackets]. Figures and illustrations are for
reference only and are not drawn to scale.
Reasons for revision are provided in Section 9,
REVISION SUMMARY.
Read these instructions thoroughly before crimping
connectors.
2. DESCRIPTION
The tool frame features two jaws, a handle, ratchet
adjustment wheel, and an emergency ratchet release.
The die set consists of an indenter (upper die) and an
anvil (lower die). The tool frame holds a die assembly
with two crimping chambers. See Figure 1. Die
retaining screws are used to secure the dies in the tool
frame.
The tool features a ratchet and an adjustment wheel
with a range of settings. The ratchet ensures that the
tool has completed the cycle and will not release until
©2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or company names may be trademarks of their respective owners.
1 of 4