408-32068 Datasheet, PDF (1/4 Pages) TE Connectivity Ltd – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools

SDE-SA Commercial Hand Tool
Assembly 1976149-1 with
Die Set Assembly 1976149-2
Instruction Sheet
408-32068
02 AUG 12 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Nut
Handle
Spacer
Locator
Stationary Jaw
Moving Jaw
Ratchet Adjustment
Wheel
Wire Crimper
(Upper Die)
Insulation Crimper
(Upper Die)
Die Set
2063195-2
Emergency
Ratchet
Release
Die Retaining
Screws
Anvil (Lower)
Wire Die
DIE ASSEMBLY
1976149-2
Anvil (Lower)
Insulation Die
CONTACT PART NUMBER
Burndy Contact
SM16ML-11TK6
Slotted
Spring
Pins
WIRE SIZE (AWG)
[16]
INSULATION SIZE
2.01-3.0 [.079-.118]
Figure 1
1. INTRODUCTION
NOTE
i
Dimensions in this instruction sheet are in
millimeters with [inches in brackets]. Figures and
illustrations are for reference only and are not
drawn to scale.
SDE-SA Commercial Hand Tool Assembly 1976149-1
consists of SDE-SA Frame Assembly 9-1478240-0
(Instruction Sheet 408-8851) and die set assembly
1976149-2. See Figure 1. The tool is used to crimp
terminal numbers provided in the table in Figure 1.
2. DESCRIPTION
The tool frame features two jaws, a handle, ratchet
adjustment wheel, and an emergency ratchet release.
Burndy is a trademark.
The die set consists of an indenter (upper die) and an
anvil (lower die). The tool frame holds a die assembly
with two crimping chambers. See Figure 1. Die
retaining screws are used to secure the dies in the tool
frame.
The tool features a ratchet and an adjustment wheel
with a range of settings. The ratchet ensures that the
tool has completed the cycle and will not release until
the handles have been FULLY closed, unless the
emergency ratchet release is rotated to manually
release the ratchet. The adjustment wheel controls the
amount of handle pressure exerted on the dies during
the crimping procedure.
CAUTION
!
The dies bottom before the ratchet releases. This
feature ensures maximum tensile performance of
the crimp. DO NOT re-adjust the ratchet.
©2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or company names may be trademarks of their respective owners.
1 of 4