408-32061 Datasheet, PDF (1/1 Pages) TE Connectivity Ltd – Extraction Tool 2161958-1 for Economy Power (EP) 2.5

Handle
Extraction Tool 2161958-1 for
Economy Power (EP) 2.5
Extraction Tool 2161958-1
Economy Power 2.5
Housing
Instruction Sheet
408-32061
12 JUL 12 Rev B
Release Tip
Latch
Figure 1
1. INTRODUCTION
Extraction Tool 2161958-1 is designed to remove
contacts from EP 2.5 connector housings.
Read these instructions thoroughly before attempting
to remove any contacts.
NOTE
i
All dimensions are in millimeters [followed by
inches in brackets]. Figures and illustrations are for
reference only, and are not drawn to scale.
2. DESCRIPTION
The tool features a handle marked with the part
number and a release tip. The tip is designed to fit into
the window of the housing and lift the locking tab to
clear the latch on the contact.
3. USING THE TOOL
1. Lightly pull back on the wire of the contact you
are extracting.
2. Insert the tip of the extraction tool into the window
as shown in Figure 2.
3. Pivot the tool clockwise and the tip will raise the
locking tab up, releasing the contact.
4. Then pull the wire out of the housing.
Pull the Wire
Pivot the Tool on
This Surface
Figure 2
4. 'MAINTENANCE AND INSPECTION
It is recommended that each tool be inspected upon
arrival to be sure it has not been damaged in transit. It
should also be inspected at regularly scheduled intervals
to be sure it remains functional.
Be sure to keep the tool clean.
5. REVISION SUMMARY
Since the previous release, the proper use guidelines
(referring to power tools) were removed.
©2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change.
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
*Trademark
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or company names may be trademarks of their respective owners.
1 of 1