408-2498 Datasheet, PDF (1/5 Pages) TE Connectivity Ltd – Crimping Head Cross Reference

Crimping Head Cross Reference
for Pneumatic Tools
Instruction Sheet
408- 2498
11 APR 11 Rev E
“626” Pneumatic Tooling Systems
Wire Size Range: 26 - 6 AWG
Crimps The Following Products:
PIDG* Terminals
SOLISTRAND* Terminals
COPALUM* Terminals
AMPLI- BOND* Terminals
Closed End Splices
PLASTI- GRIP* Terminals
Relay Tab
STRATO- THERM* Terminals
TERMI- FOIL* Terminals
Pneumatic Tool 69015
Wire Size Range: 8 - 1/0 AWG
Crimps The Following Products:
PLASTI- GRIP* Terminals
SOLISTRAND* Terminals
STRATO- THERM* Terminals
COPALUM* Terminals
AMPOWER* Terminals
AMPLI- BOND* Terminals
Figure 1
1. INTRODUCTION
The tools shown in Figure 1 are capable of crimping a
wide variety of products on solid or stranded wire
sizes 26 through 1/0. The various configurations of
the “626” Pneumatic Tooling Systems are identified in
Figure 2. All of these systems accept any of the Tool
Holder Assemblies and their associated Crimping
Heads/Adapters, as indicated. The remainder of this
instruction sheet contains tables which provide cross
referencing information on the tool, crimping head,
products crimped, and wire size ranges. In addition,
instruction sheet numbers for all crimping heads and
pneumatic tools and an explanation of product
insulation barrel expansions are provided.
Reasons for reissue are provided in Section 5,
REVISION SUMMARY.
NOTE
i
Dimensions are in millimeters [with inch
equivalents in brackets]. Figures and illustrations
are for reference only and are not drawn to scale.
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1--800--722--1111 This controlled document is subject to change.
PRODUCT INFORMATION 1--800--522--6752
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 5
LOC B