English
Language : 

408-1412 Datasheet, PDF (1/7 Pages) TE Connectivity Ltd – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools
Crimping Heads for
SOLISTRAND* and
STRATO-THERM* Terminals
Instruction Sheet
408-1412
19 APR 12 Rev C
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
1. INTRODUCTION
This instruction sheet provides information on product
application and installation, maintenance, and
inspection procedures for:
CRIMPING HEADS USED IN...
TOOL 69005
TOOL 69010
300454
38394
38923
Figure 1
These instructions may be used for heads not listed in
Figure 1 but accompanied by this instruction sheet.
For unlisted heads, us the wire strip dimensions given
in Figure 3 for an identical size head.
For information regarding general operation of the
pneumatic tool, refer to Instruction Sheet 408-1410
(packaged with the tools). Read these instructions
thoroughly before using the crimping head.
NOTE
i
Dimensions on this sheet are in millimeters [with
inches in brackets]. Figures and illustrations are for
reference only and are not drawn to scale.
Reasons for reissue are provided in Section 8,
REVISION SUMMARY.
2. DESCRIPTION
The interchangeable crimping heads have integral
jaws that close in an arc-like motion. After an operator
locates the terminal between the jaws and inserts the
wire, the trigger is depressed and the jaws close,
crimping the terminal to the wire. The jaws remain
closed until the trigger is released.
Crimping heads are coated with preservative to
prevent rust and corrosion. Wipe the preservative from
heads, particularly from crimping surfaces.
DANGER
STOP
Avoid personal injury. Keep fingers clear of
crimping jaws when activating tool.
3. INSTALLATION AND REMOVAL OF CRIMPING HEAD
3.1. Installation
1. Disconnect tool from air supply.
A
Link
Open
Crimping
Jaws
Mounting Lug
Toggle
Arm
Toggle
Lever
Assembly Pin
Lockscrew
Trigger
B
Align Links Between
Mounting Lugs of Tool
Assembly Pins
Mounting
Lug
CAUTION
!
Figure 2
Do not operate tool without having head installed
and lockscrew tightened.
2. Remove assembly pins from mounting lugs as
shown in Figure 2A.
3. Pull toggle arm forward and loosen lockscrew in
toggle arm. Do not remove lockscrew. See
Figure 2A.
©2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or company names may be trademarks of their respective owners.
1 of 7