408-1216 Datasheet, PDF (1/2 Pages) TE Connectivity Ltd – Cumulative Trauma Disorders can result from the prolonged use ofmanually powered hand tools

Extraction Tools 305183,
305183- 4, - 6, - 7, - 8, and - 13
Instruction Sheet
408- 1216
03 MAY 11 Rev D
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Plastic
and Steel
Tool
Sleeve
Aluminum
and Steel
Tool
Handle
Push Rod Button
EXTRACTION
TOOL
CONTACT
TYPE
SIZE
305183--0
D
II, III, III(+), VI, X, and
Subminiature Coaxial
305183--4 D
I
305183--6
I
305183--7
I
305183--8 D
I
Miniature Coaxial
All Sizes
14
10
8
12
20
1--305183--3--0
I
10
D Plastic and Steel — All Others: Aluminum and Steel
Figure 1
1. INTRODUCTION
The extraction tools listed in Figure 1 are designed to
remove pin and socket contacts from Multimate
connectors. Read these instructions thoroughly
before starting.
NOTE
i
Dimensions on this instruction sheet are in
millimeters [with inch equivalents in brackets].
Illustrations are for identification only and are not
drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
2. DESCRIPTION
Each tool features a handle and sleeve to release the
contact locking lance, and a push rod button to eject
the contact.
There are two styles of tools. The first style illustrated
in Figure 1 has a plastic handle and push rod button
with all other components made of steel. The second
style illustrated in Figure 1 has an aluminum push rod
button with all other components made of steel. The
part number determines the style of the tool.
3. EXTRACTION PROCEDURE
Refer to Figure 1, and select the appropriate
extraction tool according to the contact type and
contact size, to be removed. Proceed as follows:
1. For smaller wire, use Insertion Tool 91002--1 to
“unseat” the contact retention spring from the
housing contact cavity retention ledge by exerting
a small amount of force on the back of the contact.
For larger wire with sufficient column strength,
push on the contact wire.
2. Align the sleeve of the tool with the contact to
be removed. See Figure 2.
3. Holding the tool handle, insert the sleeve
straight into the contact cavity until it bottoms. To
determine if the extraction tool is fully seated on
the housing retention ledge; thereby ensuring that
the retention tines are fully retracted, a mark can
be placed on the tool sleeve when it comes to rest
on the retention ledge of an empty housing contact
cavity. Allow the push rod button to “back out” of
the handle as shown in Figure 3.
Pin Contact
(Ref)
Sleeve
Figure 2
Rotate Handle
Depress
Push Rod
Button
Sleeve Bottomed
in Cavity
Figure 3
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1--800--722--1111 This controlled document is subject to change.
PRODUCT INFORMATION 1--800--522--6752
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 2
LOC B