408-10421 Datasheet, PDF (1/1 Pages) TE Connectivity Ltd – This product is for use in a restricted access location only.

PARALIGHT*
Active Optical
Cable Assemblies
Instruction Sheet
408-10421
18 JUL 12 Rev B
1. INTRODUCTION
NOTE
This product is for use in a restricted access
location only.
i
This instruction sheet provides installation guidelines
for TE Connectivity Active Cables with TE-AC01 or
TE-AC02 prefix QSFP connectors. Proper handling
procedures should be exercised when transporting or
installing the cables. Operation of the product must be
maintained within the 0° to 70°C [32° to 158°F]
operating case temperature range. This product is for
use in a controlled environment or central office (CO)
per GR-468 section 1.5.3.1.
NOTE
i
This product does not contain any adjustable
controls.
DANGER
Use of controls or adjustments or performance of
procedures other than those specified herein may
STOP result in hazardous radiation exposure.
1. Correctly align the QSFP plug with the receptacle
as shown in Figure 1A.
2. Insert the plug into the receptacle until it bottoms.
See Figure 1B.
3. To remove the plug from the receptacle, pull back
on the “pull tab” in the indicated direction until it is
removed as shown in Figure 1C.
3. HANDLING
Maximum bend radius of the optical cable per ICEA-
596 in the unloaded and install condition is 29 mm and
in the loaded condition during installation is 58 mm.
This product is classified as a Class 1M Laser product
in accordance with IEC 60825-1:2007 and complies
with 21CFR 1040.10 and 1040-11 except for
deviations pursuant to laser notice No. 50, dated
24-Jun-2007. Maximum power of 700uW is measured
using two fibers.
NOTE
i
Product is to be installed in accordance with both
National and Local regulations and/or requirements
or other authority having jurisdiction.
2. INSTALLATION GUIDELINES FOR QSFP STYLE
CONNECTOR ENDS
Refer to Figure 1 for installation of QSFP style
connectors.
DANGER
Do not view cut or damaged fiber optic cable with
the naked eye or magnification instrument.
STOP
4. REVISION SUMMARY
• Added new type connector to Section 1
1A
1B
Align QSFP Plug
with Receptacle
Insert Plug into
Receptacle
Until it Bottoms
Pull on “Pull tab” to
Remove (DO NOT
Pull on Cable)
1C
Figure 1
©2012 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 1
LOC B