408-10261 Datasheet, PDF (1/4 Pages) TE Connectivity Ltd – Small Form- Factor Pluggable (SFP)+ Seating

Small Form- Factor Pluggable (SFP)+ Seating
Tool Kits 2018280- [ ] for
Stacked PT Connector and Cage Assemblies
Instruction Sheet
408- 10261
10 NOV 11 Rev C
Seating Tool Kit 2018280- 1 Shown
Back
Press- Fit
Contact
Seating Tool Bottomed
on Cage Assembly
2¢1 SFP+ Stacked PT
Connector and Cage
Assembly (With Gasket)
2007538- 1 (Shown)
Wall Support
(For Clarity, Shown
Not Installed)
SEATING TOOL
KIT
2018280--1
2018280--2
2018280--3
2018280--4
2018280--5
2018280--6
SFP+ CONNECTOR
AND CAGE ASSEMBLY
CONFIGURATION
2¢1
2¢2
2¢4
2¢6
2¢8
2¢5
Printed Circuit (PC)
Board (Ref)
PC Board Support
Fixture (Ref)
Figure 1
1. INTRODUCTION
SFP+ Seating Tool Kits 2018280--[ ] are used to seat
the SFP+ stacked PT connector and cage assembly
configurations given in Figure 1 onto the pc board.
The connector and cage assemblies contain press--fit
contacts to allow solderless pc board installation.
Read these instructions thoroughly before using the
seating tool kit.
NOTE
i
Dimensions on this sheet are in metric units [with
U.S. customary units in brackets]. Figures are not
drawn to scale.
support must be installed into the port(s) of the cage
assembly.
The top of the seating tool provides a surface to
accept the force applied by the application tool to seat
the connector and cage assembly onto the pc board.
During seating, the back and sides of the seating tool
protect the connector and cage assembly from
damage. The wall support supports the individual
port(s) of the cage assembly to prevent the cage
assembly from collapsing.
3. REQUIREMENTS
3.1. PC Board Support Fixture (Customer Supplied)
2. DESCRIPTION (See Figure 1)
Each seating tool kit consists of a seating tool and a
wall support. The seating tool and wall support are
also available separately. The seating tool has cutouts
(two located on each side) to accept the protruding
part of the standoffs of the cage assembly. The wall
A pc board support must be used to provide proper
support for the pc board and to protect the pc board
and product from damage. The support fixture must
be designed for specific needs using the following
recommendations:
S it should be at least 25.4 mm [1 in.] longer and
wider than the pc board.
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1--800--722--1111
All Rights Reserved
PRODUCT INFORMATION 1--800--522--6752
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.
*Trademark. Other logos, product and/or Company names may be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
1 of 4
LOC B