English
Language : 

408-10259 Datasheet, PDF (1/3 Pages) TE Connectivity Ltd – Small Form-Factor Pluggable (SFP) and zSFP
Small Form-Factor Pluggable (SFP)+ and zSFP+
Extraction Tool Kits 2063048-[ ] and 2161405-1
for Stacked PT Connector and Cage Assemblies
Cutout (2 Places)
Extraction Tool
Instruction Sheet
408-10259
19 AUG 13 Rev D
Printed Circuit (PC)
Board (Ref)
2 x 4 Stacked SFP+ Connector
and Cage Assembly
(2007538-1 Shown)
Top Push Plate
Wall Supports
Base Plate
Finger Mounting Block
EXTRACTION TOOL
2063048-1
2063048-2
2063048-3
2063048-4
2063048-5
2063048-6
2161405-1
SFP+ CONNECTOR AND CAGE
ASSEMBLY CONFIGURATION
2x4
2x1
2x2
2x6
---
---
2 x 12
zSFP+ CONNECTOR AND CAGE
ASSEMBLY CONFIGURATION
2x4
2x1
2x2
2x6
2x5
2x8
2 x 12
Figure 1
1. INTRODUCTION
SFP+ and zSFP+ Extraction Tool Kits 2063048-[ ] and
2161405-1 are used to remove the pc board from
SFP+ and zSFP+ stacked PT connector and cage
assemblies described in Figure 1. The connectors and
cage assemblies contain press-fit contacts. Read
these instructions thoroughly before using the
extraction tool kit.
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
NOTE
i
Dimensions on this sheet are in metric units [with
U.S. customary units in brackets]. Figures and
illustrations are for reference only and are not
drawn to scale.
The base plate features a finger mounting block that
holds up to six wall supports to the base plate. See
Figure 1. The top push plate is designed to be
installed onto the upper tooling and the base plate is
designed to be installed onto the lower tooling of the
application tool. The extraction tool has cutouts (one
located on each side) to accept the protruding part of
the cage assembly. Each “finger” of a wall support fits
into a port of the cage assembly.
During extraction, the back and sides of the extraction
tool protect the cage assembly from damage, the wall
supports support the individual ports of the cage
assembly, and the top push plate provides a surface to
apply an even force to extract the pc board from the
connector and cage assembly.
2. DESCRIPTION
Each extraction tool kit consists of an extraction tool, a
top push plate, base plate, and wall supports (one for
each stacked row of the cage assembly).
3. APPLICATION TOOLING REQUIREMENT
Power for the extraction tool must be provided by
application tools (with a ram) capable of supplying a
downward force of 44.5 N [10 lb] per contact.
©2013 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 3
LOC B