408-10221 Datasheet, PDF (1/4 Pages) TE Connectivity Ltd – Reasons for reissue of this instruction sheet are provided in Section 8, REVISION SUMMARY.

Compliant
Pin Contact
RJ Point Five* Connector Seating
Tool Assemblies 2063000-[ ]
Back
Instruction Sheet
408-10221
12 OCT 15 Rev D
Top
Seating Tool Bottomed
on Receptacle Connector
2 X 8 RJ Point Five
Receptacle Connector
2007669-1 (Shown)
Printed Circuit
(PC) Board (Ref)
SEATING TOOL
ASSEMBLY
2063000-1
2063000-2
RJ POINT FIVE
CONFIGURATION
2X8
2 X 12
1. INTRODUCTION
Figure 1
PC Board Support
Fixture (Ref)
RJ Point Five Connector Seating Tool Assemblies 2063000-1 and -2, shown in Figure 1, are used to seat 2 X 8
and 2 X 12 (respectively) receptacle connectors onto the pc board. The receptacle connector contains
compliant pin contacts to allow solderless pc board installation. Read these instructions thoroughly before using
the seating tool.
NOTE
Dimensions on this sheet are in metric units [with U.S. customary units in brackets]. Figures are not drawn to scale.
Reasons for reissue of this instruction sheet are provided in Section 8, REVISION SUMMARY.
2. DESCRIPTION (See Figure 1)
The seating tool consists of two sides, a back, and a top. It has cutouts (two located on each side and two
located on the back) to accept the protruding part of the standoffs of the receptacle connector.
The top of the seating tool provides a surface to accept the force applied by the application tool to seat the
receptacle connector onto the pc board. The seating tool is designed to position behind the panel ground
springs of the receptacle connector. During seating, the back and sides of the seating tool protect the
receptacle connector from damage.
3. REQUIREMENTS
3.1. PC Board Support Fixture (Customer Supplied)
A pc board support must be used to provide proper support for the pc board and to protect the pc board and
receptacle connector from damage. The support fixture must be designed for specific needs using the following
recommendations:
 it should be at least 25.4 mm [1 in.] longer and wider than the pc board
 it should have flat surfaces with holes or a channel large enough and deep enough to receive any
protruding components of the receptacle connector
© 2015 TE Connectivity family of companies
All Rights Reserved
*Trademark
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
1 of 4