English
Language : 

408-10155 Datasheet, PDF (1/4 Pages) TE Connectivity Ltd – Read these instructions thoroughly before using the seating tool kit.
Small Form-Factor Pluggable (SFP)+ and (SFT+
Enhanced) Surface Mount PT Connector and Cage
Assembly Seating Tool Kits 2018002-[ ] and 2215005-[
Instruction Sheet
408-10155
20 JAN 15 Rev C
Seating Tool Kit 2018002-1 (Shown)
Back of
Seating Tool
1 X 4 Seating Tool
(Bottomed on Cage Assembly)
1 X 4 Cage Assembly
2007576 (Shown)
Compliant
Pin Contact
Printed Circuit
(PC) Board (Ref)
1 X 4 Wall Support
(For Clarity, Not
Shown Installed
SEATING
TOOL KIT
2018002-1
2018002-2
2018002-3
2018002-4
2018002-5
2018002-6
2215005-1
2215005-2
2215005-3
SFT+ CAGE
ASSEMBLY
CONFIGURATION
1X4
1X6
1X2
1X3
1X1
1X5
---
---
---
SFP+ ENHANCED
CAGE ASSEMBLY
CONFIGURATION
---
---
---
---
---
---
1X4
1X6
1X2
APPLICATION
SPECIFICATION
114-13120
Figure 1
PC Board Support
Fixture (Ref)
NOTE: Connector not shown.
1. INTRODUCTION
SFP+ surface mount PT connector and cage assembly seating tool kits listed in Figure 1 are used to seat the
cage assemblies described in Figure 1 onto the pc board. The cage assembly contains compliant pin contacts
to allow solderless pc board installation. The seating tool is not designed to seat the connector.
Read these instructions thoroughly before using the seating tool kit.
NOTE
Dimensions on this sheet are in metric units [with U.S. customary units in brackets]. Figures and illustrations are for reference
only and are not drawn to scale.
2. DESCRIPTION (Figure 1)
Each seating tool kit consists of a seating tool and a wall support. The seating tool and wall support are also
available separately. The seating tool has cutouts (two located on each side) to accept the protruding part of
the standoffs of the cage assembly. The wall support must be installed into the ports of the cage assembly.
The top of the seating tool provides a surface to accept the force applied by the application tool to seat the
product onto the pc board. During seating, the back and sides of the seating tool protect the cage assembly
from damage. The wall support supports the individual ports of the cage assembly.
© 2015 TE Connectivity family of companies
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
1 of 4