408-10051 Datasheet, PDF (1/7 Pages) TE Connectivity Ltd – Cumulative Trauma Disorders can result from the prolonged use ofmanually powered hand tools.

Crimping Dies for
TERMINYL* and PLASTI- GRIP*
Terminals and Splices
Instruction Sheet
408- 10051
23 MAR 11 Rev C
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Typical
Crimping
Dies
Moving
Die (Nest)
Locking
Flange
Moving
Die (Nest)
Locator
Yoke Set Screw
Locator
Latch Arm
Stationary
Die (Anvil)
Shank
Adapter
Stationary
Die (Anvil)
Yoke
PART NUMBER
1901006--1
1901007--1
CRIMPING DIE
COLOR CODE DOT
Red
Blue
WIRE SIZE (AWG)
8
6
Figure 1
1. INTRODUCTION
2. DESCRIPTION
Crimping Dies 1901006--1 and 1901007--1 are used
with Battery Powered Hand Tool 1901343--1, --2, --3,
and --4 (Customer Manual 409--10070) and Battery
Powered Hand Tool 2031404--1, --11, --21, --31, and
--41 (Customer Manual 409--10103). The dies crimp
TERMINYL Terminals and Splices onto wire sizes 8
through 6 AWG, TERMINYL Splices with step--down
adapters onto wire sizes 16--14 through 6 AWG, and
PLASTI--GRIP Terminals and Splices onto wire sizes
8 through 6 AWG. Refer to Figure 1 to ensure
compatibility of crimping die part number, color code
dot, and wire size.
Each crimping die consists of a stationary die (nest)
and a moving die (anvil). The stationary die features a
locator. Each die contains a color code dot that
matches the color code of the terminal and splice.
When mated, the dies form a crimping chamber.
3. DIE INSTALLATION AND REMOVAL
3.1. Die Installation
1. Pivot the latch arm away from the yoke to open
the crimp head. See Figure 1.
2. Loosen the set screw in the yoke.
NOTE
Dimensions in this document are in millimeters
[with inches in brackets]. Figures and Illustrations
are for reference only and are not drawn to scale.
3. Insert the shank of the stationary die into the
yoke, and tighten the set screw.
4. Extend the ram until the ram set screw is visible.
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1--800--722--1111
All Rights Reserved
PRODUCT INFORMATION 1--800--522--6752
TE logo is a trademark.
*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
1 of 7
LOC B