408-10020 Datasheet, PDF (1/3 Pages) TE Connectivity Ltd – Extraction/Lance Reset Tool


Extraction/Lance Reset Tool
843996-6
Instruction Sheet
408-10020
09 MAY 11 Rev C
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Lance Release Tip
Handle
Lance Reset Portion
Micro MATE-N-LOCK*
Receptacle Contact
Locking Lance
Figure 1
1. INTRODUCTION
3. USING THE TOOL (See Figure 2
Extraction/Lance Reset Tool 843996-6 is designed to
remove Micro MATE-N-LOK receptacle contacts from
a housing and reset overly depressed contact locking
lances. See Figure 1.
Read these instructions thoroughly before attempting
to remove any contacts or resetting the locking lance.
NOTE
i
All dimensions are in millimeters (followed by
inches in brackets). Figures and illustrations are for
reference only, and are not drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 5, REVISION SUMMARY.
3.1. Extraction
1. While holding the housing, grasp the wire at
the back of the housing, and push forward toward
the mating end of the housing to disengage the
contact locking lance from the shoulder of the
circuit cavity.
2. Fully insert the extraction tool tip into the
window adjacent to the circuit cavity until it
bottoms inside the window.
3. Pull back lightly on the wire and, if necessary,
move the tool just enough to release the contact
locking lance.
2. DESCRIPTION
The tool features a handle marked with the part
number, a contact lance release tip, locking lance
reset portion, and tool stop. The contact lance release
tip is designed to depress the contact locking lance to
allow extraction of the contact. The tool stop prevents
over-insertion of the tip. The lance reset portion is
designed to reposition an overly depressed locking
lance to the proper height assuring retention of the
contact in the housing.
4. Pull the contact from the housing, then remove
the tool.
©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change.
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
*Trademark
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 3
LOC B