114-7010 Datasheet, PDF (1/20 Pages) TE Connectivity Ltd – All numerical values are in metric units

AMPMODU* 50/50 Grid Connectors
for SMT PC Board and IDC
Ribbon Cable Applications
Application Specification
114- 7010
18 MAR 11 Rev F
NOTE
i
All numerical values are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters [and
inches]. Unless otherwise specified, dimensions have a tolerance of +0.13 [+.005] and angles have a tolerance of +2_.
Figures and illustrations are for identification only and are not drawn to scale.
1. INTRODUCTION
This specification covers the requirements for application of AMPMODU 50/50 Grid SMT (Surface Mount
Technology) printed circuit (pc) board connectors, and IDC (Insulation Displacement Contact) cable
connectors. The connectors have contacts with in--row spacing on 1.27 [.050] centers and row--to--row spacing
on 1.27 [.050] centers. They are available in 10--position increments from 10 through 100; the vertical SMT
connectors are also available with 16 positions.
The SMT connectors are available as receptacles, and as vertical or right--angle pin header assemblies. They
feature solderable hold--downs that help to stabilize the connector before and after soldering. There are
unpolarized connectors with two large or two medium hold--downs, and there are polarized connectors
containing a large hold--down at the end where the stack height marking is located and a small hold--down at
the opposite end. All connectors can be placed on the pc board by hand.
The IDC connectors are available as receptacle assemblies. Each consists of a housing with insulation
displacement contacts and two unassembled covers. These connectors are designed to terminate solid or
7--strand, 30 to 28 AWG ribbon cable with an insulation diameter range of 0.74 to 0.91 [.029 to .036]. They are
terminated using manually operated tools.
When corresponding with TE Connectivity (TE) Representatives, use the terminology provided in this
specification to facilitate your inquiry for information. Basic terms and features of the connectors are provided
in Figures 1 and 2.
Receptacle
Connector
Socket Contact
SMT Connectors
Polarization
Tab
Solder
Tine
Right- Angle
Header Without
Locking Bar
Hold- Down
Support
Hold- Down
Pin Contact
Solder
Tine
Polarizing
Slot
Hold- Down
Stabilizing
Solder Tab
Locking
Bar
Polarizing
Slot
Right- Angle Header
With Locking Bar
Stack Height
Dimension
Marking
Standoff
Hold- Down
Support
Hold- Down
Header
Connector
Hold- Down
Figure 1
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1--800--722--1111
All Rights Reserved
PRODUCT INFORMATION 1--800--522--6752
TE logo is a trademark.
*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
1 of 20
For latest revision and Regional Customer Service,
visit our website at www.te.com
LOC B