108-1979 Datasheet, PDF (1/5 Pages) TE Connectivity Ltd – Product shall be of the design, construction and physical dimensions specified on the applicable product drawing.

Product
Specification
AUGAT* HOLTITE* Sockets
108-1979
11Mar11 Rev B
1.
SCOPE
1.1. Content
This specification covers performance, tests and quality requirements for the TE Connectivity (TE)
AUGAT* HOLTITE* Sockets. These sockets are designed to be press-fit into a plated through hole of a
printed circuit board. This unique design allows the plated through hole to become a component socket.
The sockets are designed to accept a .016 to .021 inch round lead (5P), .011 X .018 inch rectangular
lead (5P), .020 to .030 inch round lead (6P), .025 to .035 inch round lead (8P) and .035 to .045 inch
round lead (12P).
1.2. Qualification
When tests are performed on the subject product line, procedures specified in Figure 1 shall be used.
All inspections shall be performed using the applicable inspection plan and product drawing.
1.3. Qualification Test Results
Successful qualification testing on the subject product line has been completed. The Qualification Test
Report number for this testing is 501-500. This documentation is on file at and available from
Engineering Practices and Standards (EPS).
2.
APPLICABLE DOCUMENTS
The following documents form a part of this specification to the extent specified herein. Unless
otherwise specified, the latest edition of the document applies. In the event of conflict between the
requirements of this specification and the product drawing, the product drawing shall take precedence.
In the event of conflict between the requirements of this specification and the referenced documents,
this specification shall take precedence.
2.1. TE Documents
! 109-197: TE Test Specifications vs EIA and IEC Test Methods
! 501-500: Qualification Test Report
2.2. Commercial Standard
EIA-364: Electrical Connector/Socket Test Procedures Including Environmental Classifications
3.
REQUIREMENTS
3.1. Design and Construction
Product shall be of the design, construction and physical dimensions specified on the applicable product
drawing.
3.2. Materials
Materials used in the construction of this product shall be as specified on the applicable product
drawing.
©2011 Tyco Electronics Corporation,
a TE Connectivity Ltd. Company
All Rights Reserved
TE logo is a trademark.
| Indicates change
*Trademark
For latest revision, visit our website at www.te.com/documents.
For Regional Customer Service, visit our website at www.te.com
Other products, logos, and company names might be trademarks of their respective owners.
1 of 5
LOC B