|
MFP-B32632634 Datasheet, PDF (11/27 Pages) TDK Electronics – Metallized Polypropylene Film Capacitors (MFP) | |||
|
◁ |
B32632 ... B32634
Very high pulse (wound)
Technical data
Operating temperature range
Dissipation factor tan δ
at 20 °C
Max. operating temperature Top,max
Upper category temperature Tmax
Lower category temperature Tmin
Rated temperature TR
1.0 10-3 (at 10 kHz)
2.0 10-3 (at 100 kHz)
+110 °C
+100 °C
55 °C
+85 °C
(upper limit values)
Insulation resistance Rins
100 Gâ¦
at 20 °C, rel. humidity ⤠65%
(minimum as-delivered values)
DC test voltage
2.0 VR, 2 s
(B32632/3000 V DC: 1.2 VR, 2 s;
B32633/3000 V DC: 1.6 VR, 2 s)
Category voltage VC
TA (°C) DC voltage derating AC voltage derating
(continuous operation with VDC TA ⤠85 VC = VR
VC,RMS = VRMS
or VAC at f ⤠1 kHz)
85<TAâ¤100 VC = VR (165TA)/80 VC,RMS = VRMS (165TA)/80
Operating voltage Vop for
TA (°C) DC voltage (max. hours) AC voltage (max. hours)
short operating periods
TA ⤠85
Vop = 1.25 VC (2000 h) Vop = 1.0 VC,RMS (2000 h)
(VDC or VAC at f ⤠1 kHz)
85<TAâ¤100 Vop = 1.25 VC (1000 h) Vop = 1.0 VC,RMS (1000 h)
Damp heat test
56 days/40 °C/93% relative humidity
Limit values after damp
heat test
Capacitance change âC/C
Dissipation factor change â tan δ
Insulation resistance Rins
⤠2%
⤠1.0 10-3 (at 10 kHz)
⥠50% of minimum
as-delivered values
Reliability:
Failure rate λ
Service life tSL
1 fit (⤠2 10-9/h) at 0.5 VR, 40 °C
200 000 h at 1.0 VR, 85 °C
For conversion to other operating conditions and temperatures,
refer to chapter "Quality, 2 Reliability".
Failure criteria:
Total failure
Short circuit or open circuit
Failure due to variation
of parameters
Capacitance change âC/C
Dissipation factor tan δ
Insulation resistance Rins
> 10%
> 4 upper limit value
< 1500 Mâ¦
Please read Cautions and warnings and
Important notes at the end of this document.
Page 11 of 27
|
▷ |