MZA1210 Datasheet, PDF (1/2 Pages) TDK Electronics – Chip Beads(SMD Array) For General Signal Line

(1/2)
Chip Beads(SMD Array)
For General Signal Line
MZA Series MZA1210 Type
FEATURES
• A single MZA series chip provides noise attenuation for two
lines, making it ideal for use with I/O lines of various highly
miniaturized.
• Electronic equipment, such as portable products, which
comprise high density circuitry.
• Low crosstalk between adjacent circuits.
• Internal electrodes feature low DC resistance, minimizing
wasteful power consumption.
• Electroplated terminal electrodes accommodate reflow
soldering.
• Monolithic structure ensures high reliability.
• The products contain no lead and also support lead-free
soldering.
• It is a product conforming to RoHS directive.
APPLICATIONS
High-frequency noise countermeasure in computers, printers,
VCRs, televisions, portable telephones, and other equipment.
PRODUCT IDENTIFICATION
MZA 1210 D 121 C T
(1) (2) (3) (4) (5) (6)
(1) Series name
(2) Dimensions L× W
(3) Material code
(4) Nominal impedance
121:120Ω at 100MHz
(5) Characteristic type
(6) Packaging style
T:Taping
RECOMMENDED SOLDERING CONDITION
REFLOW SOLDERING
250 to 260˚C
230˚C
10s max.
Natural
cooling
180˚C
150˚C
Preheating
60 to 120s
Time(s)
Soldering
30 to 60s
Conformity to RoHS Directive
SHAPES AND DIMENSIONS/RECOMMENDED PC BOARD
PATTERN
1.25±0.15
0.35 to 0.40
0.35±0.15 0.35±0.15
0.65±0.10
CIRCUIT DIAGRAM
0.3
Weight: 3mg
Dimensions in mm
• No polarity
TEMPERATURE RANGES
Operating/storage
–55 to +125°C
PACKAGING STYLE AND QUANTITIES
Packaging style
Taping
Quantity
5000 pieces/reel
HANDLING AND PRECAUTIONS
• Before soldering, be sure to preheat components. The preheat-
ing temperature should be set so that the temperature difference
between the solder temperature and product temperature does
not exceed 150°C.
• After mounting components onto the printed circuit board, do not
apply stress through board bending or mishandling.
• The inductance value may change due to magnetic saturation if
the current exceeds the rated maximum.
• Do not expose the inductors to stray magnetic fields.
• Avoid static electricity discharge during handling.
• When hand soldering, apply the soldering iron to the printed cir-
cuit board only. Temperature of the iron tip should not exceed
350°C. Soldering time should not exceed 3 seconds.
• This product does not apply to flow soldering construction
method.
• Conformity to RoHS Directive: This means that, in conformity with EU Directive 2002/95/EC, lead, cadmium, mercury, hexavalent chromium, and specific
bromine-based flame retardants, PBB and PBDE, have not been used, except for exempted applications.
• Please contact our Sales office when your application are considered the following:
The device’s failure or malfunction may directly endanger human life (e.g. application for automobile/aircraft/medical/nuclear power devices, etc.)
• All specifications are subject to change without notice.
004-02 / 20070329 / e9421_mza1210.fm