DS125BR800AEVM Datasheet, PDF (7/18 Pages) TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS – SMA evaluation kit provides a complete high band-width platform to evaluate the signal integrity

www.ti.com
Quick Start Guide
4 Quick Start Guide
1. Connect J19: VIN = 3.3V or VDD = 2.5V and GND.
• For VIN = 3.3V:
Set SW7 pin1 (VDD_SEL) to the ON position (enable internal LDO regulator) and float VDD at J19.
• For VIN = 2.5V:
Set SW7 pin1 (VDD_SEL) to the OFF positions (disable internal LDO regulator) and float VIN at
J19.
2. Set jumper – J20 for VIH connection to VIN or VDD.
3. Connect 50 Ohm SMA cables to the board.
• The input signals J1 to J8 can be connected from a pattern generator.Set SW7 pin1 (VDD_SEL) to
the ON position (enable internal LDO regulator) and float VDD at J19.
• The output signals J9 to J16 can be connected to a scope.
A/B Channels
B-Channels
A-Channels
Table 3. SMA Channel Connections
Input Channel
J1 – IN_B2+, J2 – IN_B2-
J3 – IN_B3+, J4 – IN_B3-
J5 – IN_A0+, J6 – IN_A0-
J7 – IN_A1+, J8 – IN_A1-
Output Channel
J9 – OUT_B2+, J10 – OUT_B2-
J11 – OUT_B3+, J12 – OUT_B3-
J13 – OUT_A0+, J14 – OUT_A0-
J15 – OUT_A1+, J16 – OUT_A1-
4. Set the control pins for normal operation
• SW7 – RESET = 0 (enables the device): set switch pin2 to the ON position.
• SW9 – INPUT_EN = 1 (50 ohm input termination): set switches (3-2-1) = (OFF-OFF-ON).
• SW9 – MODE = VDD (enables SAS-3 / PCIe GEN3 mode): set switches (6-5-4) = (OFF-OFF-ON).
• SW6 – SD_TH = F (default signal detect threshold level): set switches (3-2-1) = (OFF-OFF-OFF).
• SW6 – LPBK - RES = F (normal operation): set switches (6-5-4) = (OFF-OFF-OFF).
SNLU151 – September 2013
Submit Documentation Feedback
DS125BR800AEVM Evaluation Kit
7
Copyright © 2013, Texas Instruments Incorporated