MA230LBC002 Datasheet, PDF (3/24 Pages) List of Unclassifed Manufacturers – MA.230 Stream 3 in 1 High Performance Adhesive Mount Combination Antenna

absolutely sure, contact Taoglas and we will test. Choosing a Taoglas antenna
with a higher peak gain than what is specified by the module manufacturer and
enlisting our help will ensure you are getting the best performance possible
without exceeding the peak gain limits.
1.1. GPS/GLONASS/GALILEO
The patent pending design incorporates internally a custom Taoglas 35mm patch
antenna on an extended integral ground-plane to deliver more than 3.5dBiC gain.
A front-end SAW filter dramatically reduces radiated spurious emissions.
1.2. Cellular 4G/3G/2G
The extended ground-plane used with an innovative internal cellular PIFA also
enables the unique wide-band 4G/3G/2G response to deliver the highest
performance possible, at 3 metres cable length. Nothing else out there comes
close in terms of consistency of efficiency and peak gain at all cellular bands,
with 70%+ at the LTE 700MHz band, again including 3 metres of cable loss. High
antenna efficiencies are absolutely critical in today’s 3G and 4G systems to
achieving targeted data-speeds and coverage.
1.3. Wi-Fi dual-band 2.4/5GHz
A powerful antenna gives maximum gain and coverage for common applications.
3dBi+ stable gain on both bands including cable loss means the antenna is ideal
for high bandwidth applications.
All this is done while still maintaining 20dB isolation between antennas. The
Stream uses shielded PTFE dielectric ultra low-loss cables that maintain low
attenuation at all frequency bands, and high noise rejection, with an average
loss of only 0.3dB per meter (0.1dB per foot), compared to 0.7dB for RG58 and
1.2dB for RG174. Because of this, the Stream maximizes chances of passing
PTCRB and network approvals first time. The Stream works best when attached
to plastic or glass, but can also be used on metal if a minimum of 40mm foam
spacing is added.
SPE-13-8-068/E/PK Page 3 of 24
MA230.A301111.B305111.C305151