PAS3225P3R3113 Datasheet, PDF (3/8 Pages) Taiyo Yuden (U.S.A.), Inc – CERAMIC TYPE POLYACENE CAPACITORS

■ RELIABILITY DATA
Items
1. Operating Temperature range
2. Max. Usable Voltage
3. Resistance to Reflow
Soldering Heat
Specifications
PAS3225P 2R6143
PAS3225P 3R3113
－30℃～＋70℃
－20℃～＋70℃
2.6V
3.3V
Capacity/Capacitance : Within initial spec.
Appearance : No noticeable abnormality
4. Floating Charge Characteristics
Capacity/Capacitance : Over 70% of initial spec.
Appearance : No noticeable abnormality
5. Charge/Discharge
Cycle Characteristics
6. Thermal Durability
7. Humidity Durability
8. Vibration Durability
Capacity/Capacitance : Over 80% of initial spec.
Appearance : No noticeable abnormality
Capacity/Capacitance : Over 80% of initial spec.
Appearance : No noticeable abnormality
Capacity/Capacitance : Over 80% of initial spec.
Appearance : No noticeable abnormality
No exterior abnormality observed :
initial spec. values retained
Test Conditions, Remark
Conduct reflow soldering twice according to the reflow soldering test condition
mentioned below.
(Conduct the reflow in the condition of the voltage of 0.3V or lower.)
Apply a max.usage voltage to the capacitor for 500 hours at max. operating
temp. and measure the floating charge characteristics after returning to normal
temperature and humidity.
Measure the charge/discharge cycle characteristics after the 10000 cycles of
charge/discharge at 25±5 ℃ with the charge/discharge cycle test condition for
each part.
Leave the capacitor in an atmosphere of 85℃±2℃ and －30±2℃ consecutively
for 96 hours each, and return to normal temperature and humidity.
Temperature : 40±2℃, Humidity : 90～95%RH Leave the capacitor for under the
condition for 96hours then return to normal temperature and humidity.
Apply a sine wave vibration of 1.5mm amplitude at frequency 10~55Hz, for 2hours
per each direction (X,Y and Z) , for 6 hours in total.
◦Reflow Soldering Test Condition
Reflow profile with lead free condition

◦Charge/Discharge Cycle Test Condition
Charging/Discharging
Resistance (Ω)
Charging Voltage (V)
Charging Time (min.)
Discharging Time (min.)
PAS3225P 2R6143 PAS3225P 3R3113
300
300
2.6
3.3
4.5
4.5
0.5
0.5
Cautions : Do not charge prior to reflow,
Set reflow condition within the range provided in "Specifications", which will
be published separately.
（
Consult with us about the details.
）
136
▶ This catalog contains the typical specification only due to the limitation of space.When you consider the purchase of our products, please check our specification.
For details of each product (characteristics graph, reliability information, precautions for use, and so on), see our Web site (http://www.ty-top.com/) .