TGL41-6.8 Datasheet, PDF (1/6 Pages) Microsemi Corporation – 500 Watt Transient Voltage Suppressor

400W Surface Mount Transient
Voltage Suppressor
TGL41-6.8 - TGL41-170CA
400W Surface Mount Transient Voltage Suppressor
Features
• Breakdown voltage from 6.8 to 170 volts
• Glass passivated junction
• Excellent clamping capability
• Low incremental surge resistance
• 400W peak pulse capability with a 10/1000us waveform,
MELF (DO-213AB)
Repetition rate (duty cycle): 0.01%
• Fast response time: typically less than 1.0ps from 0V to VBR
• For devices with VBR≥10V, ID are typically less than 1.0uA
• High temperature soldering guaranteed 250°C/10 seconds at terminals
• RoHS Compliant
Mechanical Data
Case:
Epoxy:
Terminals:
Polarity:
Mounting position:
Weight:
JEDEC DO-213AB (MELF) molded plastic body over passivated junction
Plastic package has UL flammability classification 94V-0
Solder plated, solderable per MIL-STD-750, Method 2026
Blue bands denotes the cathode which is positive with respect to the anode under normal TVS operation
Any
0.0046 Ounce, 0. 116 gram
Maximum Ratings (T Ambient=25ºC unless noted otherwise)
Symbol
Description
Value
Unit
Conditions
PPPM
Peak Pulse Power Dissipation
on 10/1000 us waveform
Minimum 400
W
Non-repetitive current pulse, per FIG.3 and
derated above TA=25° C per FIG.2
IPPM
Peak Pulse current with a
10/1000 us waveform
See Table
A
IFSM Peak Forward Surge Current
40
A
8.3ms single half sine-wave superimposed
on rated load, (JEDEC Method)
TJ,TSTG
Operating Junction and Storage
Temperature Range
-55 to 150
°C
Note: Mounted on copper pads to each terminal of 0.31 in² (8.0 mm²) per Fig.5
TAITRON COMPONENTS INCORPORATED www.taitroncomponents.com
Tel: (800)-TAITRON (800)-824-8766 (661)-257-6060
Fax: (800)-TAITFAX (800)-824-8329 (661)-257-6415
Rev. A/DX 2007-06-04
Page 1 of 6