SPW Datasheet, PDF (1/4 Pages) Vishay Siliconix – Carbon Film Resistors, Special Purpose High Frequency Load (Tubes)

Indoor Selectable
Output Speaker Strobes
and Dual Voltage
Evacuation Speakers
The new SpectrAlert^® Advance selectable output
speaker strobes and dual evacuation speakers can
reduce ground faults and allow faster installation.
Features
• Plug-in design
• Protective cover isolates speaker components, reduces ground
faults
• Electrical compatibility with existing SpectrAlert products
• Field selectable candela settings on wall and ceiling units:
Standard: 15, 15/75, 30, 75, 95, 110, 115
High: 135, 150, 177, 185
• Shorting spring on mounting plate tests continuity before
installation
• Rotary switch simplifies field selection of speaker voltage (25 and
70.7 Vrms) and power settings (¼, ½, 1 and 2 watts)
• Universal mounting plate for wall- and ceiling-mount units
• Compatible with System Sensor synchronization protocol
• SP speakers offer high fidelity sound output
• SPV speakers offer high volume sound output
• Automatic selection of 12- or 24-volt operation at 15 and 15/75
candela
• No extension ring required
• Ceiling and wall mount application
• Optional tamper resistant Torx head screw included
Agency Listings
The SpectrAlert Advance Series of speakers and speaker strobes
is designed to reduce ground faults. The plug-in design allows the
installer to pre-wire mounting plates and dress the wires before
plugging in the speakers. The plastic cover prevents nicked wires by
covering exposed speaker components.
This design also allows faster installations with instant feedback to
ensure that wiring is properly connected, rotary switches to select
voltage and power settings, and 11 field selectable candela settings
for wall and ceiling speaker strobes.
The low total harmonic distortion of the SP speaker offers high
fidelity sound output while the SPV speaker offers high volume
sound output for use in high ambient noise applications.
SpectrAlert Advance makes installation easy
• Attach a universal mounting plate to a 4 × 4 × 21⁄8 inch back box .
Flush mount applications are achievable without the need for an
extension ring.
• Connect the notification appliance circuit or speaker wiring to the
terminals on the mounting plate.
• Attach the speaker or speaker strobe to the mounting plate by
inserting the product tabs into the mounting plate grooves. Rotate
the device into position to lock the product pins into the mounting
plate terminals. The device will temporarily hold in place with a
catch until it is secured with a captured mounting screw.
S4048
7320-1653:201
10-08-E