RP12 Datasheet, PDF (1/4 Pages) Systemsensor advanced ideas. – ADA Strobe Retrofit Plate

RP12/24ADA
ADA Strobe
Retrofit Plate
A Division of Pittway
3825 Ohio Avenue, St. Charles, IL 60174
1-800-SENSOR2 (736-7672), Fax [phone]
http://www.systemsensor.com
Models Available
RP2415ADA
RP241575ADA
RP2475ADA
RP24110ADA
RP1215ADA
RP121575ADA
Features
• Fits most 4″ or 5″ square horn or speaker
• Multiple light intensities
–24 VDC: 15,15/75, 75 or 110 cd models
–12 VDC: 15 or 15/75 cd models
• Low strobe current draw. 93 mA on the RP241575ADA
with regulated power
• Low installed cost
• No measurable strobe in-rush in excess of peak current
• Intended for primary signaling
• “Installer Easy”
–Plug-in terminal strip
–Wire strip guage and wiring
diagram on back
• Wall mount only
System Sensor RP12/24ADA Series Strobe Retrofit
Plate complies with the Americans with Disabilities Act
(ADA) and the demanding requirements of the UL 1971
Standard for the Hearing Impaired. The 15/75 version is
UL 1971 listed at 15 cd.
The new model RP12/24ADA Series Retrofit Plate
allows adding an ADA compliant visible notification to
most existing 4 or 5 inch square horns or speakers. To
insure compliance with ADA and UL 1971, use the System
Sensor 75 candela models for non-sleeping areas, and the
110 candela models for sleeping areas.
Available in red only at 12 or 24 VDC, the RP12/
24ADA Series Strobe Retrofit Plate can be mounted
directly to a standard 4″ backbox.
Specifications
Input terminals:
18 – 12 AWG
Dimensions:
Shipping Weight:
5⁷/₈″
3″
RP12/24ADA
Series Strobes:
14 oz. (397g)
Operating
Temperature Range: 32° F to 120° F (0° C to 49° C)
7³/₄″
Mounting:
Surface:
4″ × 4″ × 1¹/2″ standard backbox
(2¹/8″ recommended)
Semiflush:
4″ × 4″ × 1¹/2″ standard backbox
(2¹/8″ recommended)
© System Sensor 8/96
This document is not intended to be used for installation purposes.
APPROVED
A05-249-01