MOD400R Datasheet, PDF (1/2 Pages) Systemsensor advanced ideas. – Field Sensitivity Test Module

MOD400R
Field Sensitivity
Test Module
A Division of Pittway
3825 Ohio Avenue, St. Charles, IL 60174
1-800-SENSOR2 (736-7672), Fax [phone]
http://www.systemsensor.com
Models Available
MOD400R Field Sensitivity Test Module
Features
• Compatible with all System Sensor direct wire and plug-
in smoke detectors (100, 200, 300, 400, and 500 series),
or System Sensor’s DH100, DH200, DH400 and DH500
series duct smoke detectors, ionization or
photoelectronic
• Fulfills NFPA 72 requirement for field sensitivity testing
• Interfaces with standard DC voltmeter or multimeter
• Low battery diagnostic
–When connected to a voltmeter, the MOD400R
monitors its own battery voltage
• Quickly tests sensitivity of detectors without putting
system into alarm
The MOD400R Field Sensitivity Test Module is designed
to check the sensitivity of System Sensor’s 100, 200, 300,
400, and 500 Series conventional detectors or System
Sensor’s DH100, DH200, DH400 and DH500 series duct
smoke detectors, to fulfill the NFPA 72 requirement for
detector sensitivity testing.
The test module can be connected to any DC voltmeter
(meter movement of 10K ohms/v or greater) to obtain a
reading which correlates to the detector’s sensitivity range.
MOD400R Specifications
Dimensions:
Shipping Weight:
4¹/2″ × 3¹/8″ × 1¹/2″
(11.43 cm × 7.93 cm × 3.81 cm)
8.4 oz (238 gm)
Test Capability:
Battery:
System Sensor 100, 200, 300,
400, 500 Series Detectors
System Sensor DH100, DH200,
DH400, DH500 series duct
smoke detectors
9 V alkaline (1 year life)
© System Sensor 8/98
APPROVED
This document is not intended to be used for installation purposes.
A05-193-02