B112LP Datasheet, PDF (1/4 Pages) Systemsensor advanced ideas. – Plug-in Detector Base

INSTALLATION AND MAINTENANCE INSTRUCTIONS
B112LP Plug-in Detector Base
For use with the following smoke detectors:
IN US:
1151, 2151
IN CANADA: 1151A, 2151A
IN EUROPE: 1151E, 2151E
3825 Ohio Avenue
St. Charles, Illinois 60174
1-800-SENSOR2, FAX: [phone]
Specifications
Base Diameter:
6.2 inches (157 mm)
Base Height:
0.95 inches (24 mm)
Weight:
0.3 lb. (137 g)
Mounting:
4-inch square box with or without plaster ring. Min. depth–1.5 inches
3-1/2-inch octagon box. Min. depth–1.5 inches
Operating Temperature Range: 0° to 49°C (32° to 120°F)
Operating Humidity Range:
10% to 93% Relative Humidity, Noncondensing
Electrical Ratings - includes base and detector
System Voltage:
24 VDC
Maximum Ripple Voltage:
4 Volts peak-to-peak
Start-Up Capacitance:
0.02µF Maximum
Standby Ratings:
20 VDC Minimum
29 VDC Maximum
120 µA Maximum
Alarm Ratings:
17 mA Minimum
36 mA Maximum
Reset Voltage:
1.4 VDC Minimum
Reset Time:
0.3 Seconds Maximum
(The optional RA400Z operates within specified detector alarm currents.)
Start-up Time:
34.0 Seconds Maximum
Relay Contact Ratings:
Resistive or Inductive (60% Power Factor)
Form A:
2.0 A @ 30 VAC/DC
Form C:
2.0 A @ 30 VAC/DC
0.6 A @ 110 VDC
1.0 A @ 125 VAC
Before Installing
Please thoroughly read the System Sensor manual I56-407,
Guide for Proper Use of System Smoke Detectors, which pro-
vides detailed information on detector spacing, placement,
zoning, wiring, and special applications. Copies of this
manual are available at no charge from System Sensor. (For
installation in Canada, refer to CAN/ULC-S524, Standard
for the Installation of Fire Alarm Systems and CEC Part 1,
Sec. 32.)
NOTICE: This manual should be left with the owner/user
of this equipment.
IMPORTANT: The detector used with this base must be
tested and maintained regularly following NFPA 72 require-
ments. The detector used with this base should be cleaned
at least once a year.
General Description
The Model B112LP detector base is designed for use with
System Sensor model 2151 photoelectronic and 1151 ioniza-
tion detector heads. This four-wire base is equipped with
screw terminals for the connection of power, ground, and
an optional remote annunciator.
Mounting
The detector base mounts directly to 3-1/2 inch and 4-inch
octagon boxes and 4-inch square boxes, with or without
plaster rings. To mount the base, remove the decorative
ring by rotating it in either direction to unhook the snaps
before separating the ring from the base. Use the screws
supplied with the junction box to attach the base to the box
through the appropriate slots in the base (see Figure 1).
Position the decorative ring around the base and rotate it in
either direction until the ring snaps into place.
D150-03-00
1
I56-597-03R