English
Language : 

MQME-28-P Datasheet, PDF (8/12 Pages) SynQor Worldwide Headquarters – HIIGH RELLIIABIILLIITTY EMI FIILLTTER
Technical Specification
MQME-28-P
Current: 20 A
RTCA/DO-160E SECTION 22 COMPLIANCE MATRIX
(LIGHTNING INDUCED TRANSIENT SUSCEPTIBILITY)
The following table shows the RTCA/DO-160 Section 22 requirements that have been met* by a stand-alone setup comprised of:
- MQME-28-P (or –T) Filter
- MQFL-28-05S DC/DC Converter
- Resistive Load
- Metal Chassis Plane
- Unshielded Power Cable Bundle
Pin Injection
Single- and
Multiple-Stroke
Cable Induction
Single- and
Multiple-Stroke
Ground Injection
Multiple-Burst
Cable Induction
Waveform
3
4
5a
2
3
4
5a
3
Maximum Level Passed
4
4†
4†
4**
4
4
4
Test Conditions
Signal applied to +Vin pin. Input Return
pin connected to system ground
Signal applied to unshielded power
cable bundle
Signal applied between metal ground
plane and system ground
4
Signal applied to unshielded power
cable bundle
Met by any MQME Filter
Met by an MQME Filter having the
Transient Suppression and Reverse
Polarity Protection Features
* Requirement is deemed to have been met as long as transient deviations in the converter’s output voltage remain within ±10% of
its initial value.
† For these waveforms at Level 3 and above, an external transient suppressor of sufficient energy rating must placed across the filter’s
input pins to keep the differential transient input voltage below +200V/-50V. Negative polarity waveforms may cause power flow to
the converter to be interrupted long enough to cause a graceful shutdown and restart of the converter. Also, the reverse voltage pro-
tection feature of the -T filter is required to protect the converter (but not the filter) from negative polarity waveform.
** For this waveform at a Level 4 and above, external transient suppressors of sufficient energy rating must be added between the fil-
ter’s input power pins and its case to keep the common-mode transient input voltage below +800V.
Product # MQME-28-P
Phone 1-888-567-9596
www.synqor.com
Doc.# 005-2ME028P Rev. A 5/1/08
Page 8