MCOTS-F-270-P-HT Datasheet, PDF (3/9 Pages) SynQor Worldwide Headquarters – All capacitors are X7R multi-layer ceramic

MCOTS-F-270-P-HT
Current: 9A
MCOTS-F-270-P-HT ELECTRICAL CHARACTERISTICS
Tb = 25 °C, Vin=270V DC ±5%, Iout=9A unless otherwise noted; full operating temperature range is -55 °C to +100 °C baseplate temperature.
Specifications subject to change without notice.
Parameter
Min. Typ. Max. Units Notes & Conditions
ABSOLUTE MAXIMUM RATINGS
Input Voltage
Continuous
-500
500
V
Transient (≤ 1 s)
-630
630
V
Isolation Voltage
-2500
2500
V Input/Output to Common-mode pins
Output Current
9
A Vin = 155V
Operating Case Temperature
-55
100
°C Baseplate Temperature
Storage Case Temperature
-65
135
°C
RECOMMENDED OPERATING CONDITIONS
Input Voltage
Continuous
-500
500
V Operating
Transient (1 s, Rs* = 0 Ω)
-630
630
V * Rs = Source Impedance
Output Current (continuous)
-9
9
A
ELECTRICAL CHARACTERISTICS
Output Voltage (continuous)
Vout = Vin - (Iin x Rdc)
V
DC Resistance (Rdc)
Tcase = 25°C
83
mΩ
Tcase = 100°C
106
mΩ
Power Dissipation (9A output current)
Vin = 155V
Tcase = 25°C
7
W
Tcase = 100°C
9
W
Total Differential-Mode Capacitance
2
µF Measured across output pins
Total Common-Mode Capacitance
0.2
µF Measured between any pin to case
Bulk Capacitor
6
µF Measured without a DC bias
Damping Resistor
1.2
Ω
Noise Attenuation
See Figure A
Isolation Resistance (any pin to case)
30
MΩ
RELIABILITY CHARACTERISTICS
Calculated MTBF (MIL-STD-217F2)
GB @ Tcase = 70ºC
5.0
10⁶ Hrs.
AIF @ Tcase = 70ºC
0.25
10⁶ Hrs.
WEIGHT CHARACTERISTICS
Device Weight
151
g
Electrical Characteristics Notes
1. Only the M grade products are tested at three temperatures. The S grade products are tested at one temperature. Please refer to the Mil-COTS
Screening table for details.
* Rs = Source Impedance
Product # MCOTS-F-270-P-HT
Phone [phone]
Doc.# 005-0006232
Rev. C
10/21/16
Page 3