PQ60240QGA05 Datasheet, PDF (2/13 Pages) SynQor Worldwide Headquarters – Quarter-brick DC/DC Converter

Technical Specification
MECHANICAL
DIAGRAM
0.14
(3.6)
1.45
(36.8)
0.43
(10.9)
0.600
(15.24)
0.300
(7.62)
2.30
(58.4)
2.00
(50.8)
Top View
Input: 35 - 75 V
Output: 24 V
Current: 5.0 A
Package: Quarter-brick
0.150
(3.81)
0.300
(7.62)
0.450
(11.43)
0.600
(15.24)
Bottom side
Clearance
See Note 9
0.060+.022/-.032
(1.52+.56/-.81)
Lowest
Component
Load Board
0.43
(10.9)
Flanged Pin
See Note 10
0.145
(3.68)
See Note 3
Side View
NOTES
1) Pins 1-3, 5-7 are 0.040” (1.02mm) diameter with
0.080” (2.03 mm) diameter standoff shoulders.
2) Pins 4 and 8 are 0.062” (1.57 mm) diameter with 0.100”
(2.54 mm) diameter standoff shoulders.
3) Other pin extension lengths available.Recommended pin
length is 0.03” (0.76mm) greater than the PCB thickness.
4) All Pins: Material - Copper Alloy
Finish (RoHS 6/6) - Matte Tin over Nickel plate
5) Undimensioned components are shown for visual reference only.
6) All dimensions in inches (mm)
Tolerances: x.xx+0.02 in. (x.x+0.5mm)
x.xxx+0.010 in. (x.xx+0.25mm)
7) Weight: 1.5 oz. (42 g) typical
8) Workmanship: Meets or exceeds IPC-A-610C Class II
9) UL/TUV standards require a clearance greater than 0.04” (1.02mm)
between input and output for basic insulation. This issue should be
considered if any copper traces are on the top side of the user’s
board. Note that the ferrite cores are considered part of the input/
primary circuit.
10) The flanged pins are designed to permit surface mount solder-
ing (allowing to avoid the wave soldering process) through the
use of the flanged pin-in-paste technique.
PIN DESIGNATIONS
Pin No.
1
2
Name
Vin(+)
ON/OFF
3
Vin(–)
4
Vout(–)
5
SENSE(–)
6
TRIM
7
SENSE(+)
8
Vout(+)
Function
Positive input voltage
TTL input to turn converter
on and off, referenced to
Vin(–), with internal pull up.
Negative input voltage
Negative output voltage
Negative remote sense¹
Output voltage trim²
Positive remote sense³
Positive output voltage
Notes:
1. SENSE(–) should be connected to Vout(–) either remotely or at
the converter.
2. Leave TRIM pin open for nominal output voltage.
3. SENSE(+) should be connected to Vout(+) either remotely or at
the converter.
Product # PQ60240QGA05
Phone [phone]
www.synqor.com
Doc.# 005-2-QGA624D Rev. B 10/01/08
Page 2