PQ60033EGL20 Datasheet, PDF (2/13 Pages) SynQor Worldwide Headquarters – Eighth-brick DC/DC Converter

Technical Specification
MECHANICAL
DIAGRAM
0.15
(3.8)
0.14
(3.56)
2.30
(58.42)
2.00
(50.8)
0.90
(22.86)
0.600
(15.24)
0.300
(7.62)
Top View
Input: 35-75 V
Output: 3.3 V
Current: 20 A
Package: Eighth-brick
0.150
(3.81)
0.300
(7.62)
0.450
(11.43)
0.600
(15.24)
Side View
Bottom side
Clearance
See Note 9
0.019 +0.013
(0.48 +0.33)
EGA Option
0.076 (1.93)
min clearance
See Note 9
Lowest
Component
Load Board
Flanged Pin
See Note 10
0.335
(8.5)
EGA Option
0.424 (10.76)
max height
See Note 9
0.110
(2.79)
See Note 3
NOTES
1) Pins 1-3, 5-7 are 0.040” (1.02mm) diameter. with 0.080”
(2.03mm) diameter standoff shoulders.
2) Pins 4 and 8 are 0.062” (1.57 mm) diameter with 0.100”
(2.54 mm) diameter standoff shoulders.
3) Other pin extension lengths available. Recommended pin
length is 0.03” (0.76mm) greater than the PCB thickness.
4) All Pins: Material: Copper Alloy
Finish (RoHS 5/6) - Tin/Lead over Nickel plate
Finish (RoHS 6/6) - Matte Tin over Nickel plate
5) Undimensioned components are shown for visual reference only.
6) All dimensions in inches (mm)
Tolerances: x.xx +/-0.02 in. (x.x +/-0.5mm)
x.xxx +/-0.010 in. (x.xx +/-0.25mm)
7) Weight: 0.68 oz. (19 g) typical
8) Workmanship: Meets or exceeds IPC-A-610C Class II
9) Modules can be ordered as EGA option that have different
pins to provide a minimum bottom side clearance of 0.076”
while increasing maximum height to 0.424”. See ordering
page for more information.
10) The flanged pins are designed to permit surface mount
soldering (allowing to avoid the wave soldering process)
through the use of the flanged pin-in-paste technique.
Pin No.
1
2
3
4
5
6
7
8
PIN DESIGNATIONS
Name
Function
Vin(+)
Positive input voltage
ON/OFF
TTL input to turn converter
on and off, referenced to
Vin(-), with internal pull up.
Vin(-)
Negative input voltage
Vout(-)
Negative output voltage
SENSE(-) Negative remote sense¹
TRIM
Output voltage trim²
SENSE(+) Positive remote sense³
Vout(+)
Positive output voltage
Notes:
1. SENSE(–) should be connected to Vout(–) either remotely or at the converter.
2. Leave TRIM pin open for nominal output voltage.
3. SENSE(+) should be connected to Vout(+) either remotely or at the converter.
Product # PQ60033EGL20
Phone [phone]
www.synqor.com
Doc.# 005-2EG633D Rev. A 1/7/08
Page 2