PQ60025QGA25 Datasheet, PDF (2/13 Pages) SynQor Worldwide Headquarters – 25 Amp, No Heatsink, Isolated DC/DC Converter

MECHANICAL
DIAGRAM
0.14
(3.6)
1.45
(36.8)
0.43
(10.9)
0.600
(15.24)
0.300
(7.62)
Technical Specification
Quarter
Brick
48Vin 2.5Vout 25A
2.30
(58.4)
2.00
(50.8)
0.150
(3.81)
0.300
(7.62)
Top View
0.450
(11.43)
0.600
(15.24)
Bottom side
Clearance
See Note 9
0.063+/-0.026
(1.60+/-0.66)
Lowest
Component
Load Board
Max. Height
0.40
(10.2)
Side View
0.145
(3.68)
See Note 3
NOTES
1) Pins 1-3, 5-7 are 0.040” (1.02mm) diameter with
0.080” (2.03 mm) diameter standoff shoulders.
2) Pins 4 and 8 are 0.062” (1.57 mm) diameter with
0.100” (2.54 mm) diameter standoff shoulders.
3) Other pin extension lengths available. Recommended pin
length is 0.03” (0.76mm) greater than the PCB thickness.
4) All Pins: Material - Copper Alloy
Finish - Tin/Lead over Nickel plate
5) Undimensioned components are shown for visual
reference only.
6) All dimensions in inches (mm)
Tolerances: x.xx +/-0.02 in. (x.x +/-0.5mm)
x.xxx +/-0.010 in. (x.xx +/-0.25mm)
7) Weight: 1.2 oz. (34 g) typical
8) Workmanship: Meets or exceeds IPC-A-610C Class II
9) UL/TUV standards require a clearance greater than 0.04”
(1.02mm) between input and output for Basic insulation. This
issue should be considered if any copper traces are on the top
side of the user’s board. Note that the ferrite cores are consid-
ered part of the input/primary circuit.
Pin No.
1
2
3
4
5
6
7
8
PIN CONNECTIONS
Name
Function
Vin(+)
Positive input voltage
ON/OFF
TTL input to turn converter
on and off, referenced to
Vin(-), with internal pull up.
Vin(-)
Negative input voltage
Vout(-)
Negative output voltage
SENSE(-) Negative remote sense¹
TRIM
Output voltage trim²
SENSE(+) Positive remote sense³
Vout(+)
Positive output voltage
Notes:
1. Pin 5 must be connected to Vout(-).
2. Leave Pin 6 open for nominal output voltage.
3. Pin 7 must be connected to Vout(+).
Product # PQ60025QGA25
Phone [phone]
Doc.# 005-2QG625D Rev. B
6/26/02
Page 2