PQ60050HPA45 Datasheet, PDF (11/13 Pages) SynQor Worldwide Headquarters – 225 Watt, No Heatsink, Isolated DC/DC Converter

output current path from converter output pins to sense point, 2)
a release of a short-circuit condition, or 3) a release of a cur-
rent limit condition. Load capacitance determines exactly how
high the output voltage will rise in response to these conditions.
After 200 ms the converter will automatically restart.
Over-Temperature Shutdown: A temperature sensor on
the converter senses the average temperature of the module.
The thermal shutdown circuit is designed to turn the converter
off when the temperature at the sensed location reaches the
Over-Temperature Shutdown value. It will allow the converter to
turn on again when the temperature of the sensed location falls
by the amount of the Over-Temperature Shutdown Restart
Hysteresis value.
Technical Specification
Half
Brick
48Vin 5.0Vout 45A
cuit diagram which details the input filtering and voltage trim-
ming.
Input Filtering and External Capacitance: Figure E
below provides a diagram showing the internal input filter com-
ponents. This filter dramatically reduces input terminal ripple
current, which otherwise could exceed the rating of an external
electrolytic input capacitor. The recommended external input
capacitance is specified in the “Input Characterisitcs” section.
More detailed information is available in the application note
titled “EMI Characteristics” on the SynQor website.
APPLICATION CONSIDERATIONS
Input System Instability: This condition can occur
because any DC/DC converter appears incrementally as a
negative resistance load. A detailed application note titled
“Input System Instability” is available on the SynQor web site
(www.synqor.com) which provides an understanding of why
this instability arises, and shows the preferred solution for cor-
recting it.
Application Circuits: Figure D below provides a typical cir-
Vin(+)
Vout(+)
Electrolytic
Vsense(+)
Vin
External
Input
Capacitor
47µF
ON/OFF
R_trim-up
Trim
or
Filter
Vsense(^_)
R_trim-down C_load
I_load
Vin(^_)
Vout(^_)
Figure D: Typical application circuit (negative logic unit, permanently enabled).
L
Vin(+)
C₁
C₂
Vin(^_)
Figure E: Internal Input Filter Diagram (component values listed on page 3).
Product # PQ60050HPA45
Phone [phone]
Doc.# 005-2HP650K Rev. C
4/16/04
Page 11