PQ60525HTA04 Datasheet, PDF (1/14 Pages) SynQor Worldwide Headquarters – Half-brick DC/DC Converter

Technical
Specification
PQ60525HTA04
48Vin 52.5Vout 200W 2250Vdc
Half-brick
Input
Output
Power Isolation DC/DC Converter
The PQ60525HTA04 PowerQor^™ Tera converter is a next-
generation, board-mountable, isolated, fixed switching fre-
quency DC/DC converter that uses synchronous rectification
to achieve extremely high conversion efficiency. The module
is ideally suited to support the IEEE 802.3af standard for
Power Over LAN and VoIP applications. The Tera series
converters offer the maximum useable output current for any
standard “half-brick” module. The Tera units also feature
active current sharing for N+1 and parallel applications.
Operational Features
• Ultra-high efficiency, 92% at full rated load current
• Delivers up to 200 Watts of output power with mini-
mal derating - no heatsink required
• Wide input voltage range: 35V – 75V, with 100V
100ms input voltage transient capability
• Fixed frequency switching provides predictable EMI
performance
PQ60525HTA04 Module
Control Features
• On/Off control referenced to input side (positive and
negative logic options are available)
• Remote sense for the output voltage compensates for
output distribution drops
• Output voltage trim permits custom voltages and voltage
margining
Mechanical Features
• Industry standard half-brick pin-out configuration
• Industry standard size: 2.3” x 2.4” (58.4 x 61.0mm)
• Total height only 0.43” (11.2mm), permits better air-
flow and smaller card pitch
• Total weight: 2.6 oz. (75 grams)
Protection Features
• Input under-voltage lockout disables converter at low
input voltage conditions
• Output current limit and short circuit protection
• Active back bias limit prevents damage to converter
from external load induced pre-bias
• Output over-voltage protection
• Thermal shutdown
Safety Features
• 2250V, 30 MΩ input-to-output isolation
• UL/cUL 60950 recognized (US & Canada), basic insu-
lation rating
• TUV certified to EN60950
• Meets 72/23/EEC and 93/68/EEC directives
• Meets UL94V-0 flammability requirements
Optional Features (full-feature)
• Active current share for N+1 and parallel applications
• External Clock Synchronization pin for better EMI char-
acteristics
• Startup Synchronization pin for more consistent start-up
sequence
• ORing FET drive supply for efficient ORing protection
Product # PQ60525HTA04
Phone [phone]
www.synqor.com
Doc.# 005-2HT652F Rev. B
03/08/05
Page 1