|
PQ60033QPA45 Datasheet, PDF (1/14 Pages) SynQor Worldwide Headquarters – Quarter-brick DC/DC Converter | |||
|
Technical
Specification
PQ60033QPA45
48Vin 3.3Vout 45Amp 2000Vdc Quarter-brick
Input
Output
Current
Isolation
DC/DC Converter
The PQ60033QPA45 PowerQor® Peta quarter-brick converter
is a next-generation, board-mountable, isolated, fixed switch-
ing frequency DC/DC converter that uses synchronous rectifi-
cation to achieve extremely high conversion efficiency. The
power dissipated by the converter is so low that a heatsink is
not required, which saves cost, weight, height, and applica-
tion effort. All of the power and control components are
mounted to the multi-layer PCB substrate with high-yield surface
mount technology. Since the PowerQor converter has no
explicit thermal interfaces, it is extremely reliable. The Peta
series offers industry leading output currents for any standard
quarter-brick module. RoHS compliant (see page 13).
Operational Features
⢠Ultra-high efficiency, 90% at full load current
⢠Delivers up to 45 amps of output current with minimal
derating - no heatsink required
⢠Wide input voltage range: 35V â 75V, with 100V
100ms input voltage transient capability
⢠Fixed frequency switching provides predictable EMI
performance
⢠No minimum load requirement means no preload
resistors required
Mechanical Features
⢠Industry standard quarter-brick pin-out configuration
⢠Industry standard size: 1.45â x 2.3â (36.8x58.4mm)
⢠Total height less than 0.45â (11.4mm), permits better
airflow and smaller card pitch
⢠Total weight: 1.5 oz. (42 grams)
⢠Flanged pins designed to permit surface mount solder-
ing (avoid wave solder) using FPiP technique
Control Features
⢠On/Off control referenced to input side (positive and
negative logic options are available)
⢠Remote sense for the output voltage compensates for
output distribution drops
⢠Output voltage trim permits custom voltages and volt-
age margining
PQ60033QPA45 Module
Protection Features
⢠Input under-voltage lockout disables converter at low
input voltage conditions
⢠Output current limit and short circuit protection protects
converter and load from permanent damage and conse-
quent hazardous conditions
⢠Active back bias limit prevents damage to converter
from external load induced pre-bias
⢠Output over-voltage protection protects load from dam-
aging voltages
⢠Thermal shutdown protects converter from abnormal
environmental conditions
Safety Features
⢠2000V, 30 MW input-to-output isolation provides
input/output ground separation
⢠UL/cUL 60950-1 recognized (US & Canada), basic
insulation rating
⢠TUV certified to EN60950-1
⢠Meets 72/23/EEC and 93/68/EEC directives which
facilitates CE Marking in userâs end product
⢠Board and plastic components meet UL94V-0 flamma-
bility requirements
Product # PQ60033QPA45
Phone 1-888-567-9596
www.synqor.com
Doc.# 005-2QP633F Rev. C
9/21/07
Page 1
|
▷ |