|
PQ60033HMA30 Datasheet, PDF (1/14 Pages) SynQor Worldwide Headquarters – 30 Amp, No Heatsink, Isolated DC/DC Converter | |||
|
Technical Specification
Half
Brick
48Vin 3.3Vout 30A
30 Amp, No Heatsink, Isolated DC/DC Converter
The PQ60033HMA30 PowerQor⢠Mega converter
is a next-generation, board-mountable, isolated,
fixed switching frequency DC/DC converter that uses
synchronous rectification to achieve extremely high
conversion efficiency. The power dissipated by the
converter is so low that a heatsink is not required,
which saves cost, weight, height, and application effort.
The Mega series converters offer increased useable
output current for a standard âhalf-brickâ module.
The Mega units also feature active current sharing
for N+1 and parallel applications.
Operational Features
⢠Ultra-high efficiency, 90% at full rated load current
⢠Delivers up to 30 amps of output current with mini-
mal derating - no heatsink required
⢠Wide input voltage range: 35V â 75V, with 100V
100ms input voltage transient withstand
⢠Fixed frequency switching provides predictable EMI
performance
Mechanical Features
⢠Industry standard pin-out configuration
⢠Industry standard size: 2.3â x 2.4â
⢠Total height only 0.40â, permits better airflow and
smaller card pitch
⢠Total weight: 1.9 oz. (54 grams)
Safety Features
⢠2000V, 10 M⦠input-to-output isolation
⢠UL/cUL 60950 recognized (US & Canada), basic
insulation rating
⢠TUV certified to EN60950
⢠Meets 72/23/EEC and 93/68/EEC directives
⢠Meets UL94V-0 flammability requirements
Product # PQ60033HMA30
Phone 1-888-567-9596
PQ60033HMA30 Module
Protection Features
⢠Input under-voltage lockout disables converter at
low input voltages conditions
⢠Output current limit and short circuit protection
⢠Output over-voltage protection
⢠Thermal shutdown
Control Features
⢠On/Off control referenced to input side (positive
and negative logic options are available)
⢠Remote sense for the output voltage compensates
for output distribution drops
⢠Output voltage trim permits custom voltages and
voltage margining
Optional Features (Full-Feature modules)
⢠Active current share for N+1 and parallel applications
⢠External Clock Synchronization pin for better EMI
characteristics
⢠Startup Synchronization pin for more consistent start-
up sequence
⢠ORing FET drive supply for efficient ORing protection
Doc.# 005-2HM633B Rev. D
4/9/03
Page 1
|
▷ |