PQ60018QPA60 Datasheet, PDF (1/14 Pages) SynQor Worldwide Headquarters – Quarter-brick DC/DC Converter

Technical
Specification
PQ60018QPA60
48 V
Input
1.8 V
Output
60 A
Current
2000 Vdc
Isolation
Quarter-brick
DC/DC Converter
The PQ60018QPA60 PowerQor^™ Peta Quarter-brick
converter is a next-generation, board-mountable, isolated,
fixed switching frequency DC/DC converter that uses
synchronous rectification to achieve extremely high
conversion efficiency. The power dissipated by the converter
is so low that a heatsink is not required, which saves cost,
weight, height, and application effort. All of the power
and control components are mounted to the multi-layer PCB
substrate with high-yield surface mount technology. Since
the PowerQor converter has no explicit thermal interfaces, it
is extremely reliable. The Peta series offers industry leading
output currents for any standard quarter-brick module. RoHS
Compliant see last page.
Operational Features
PQ60018QPA60 Module
• Ultra-high efficiency, 90% half load, 87% full load
• Delivers up to 60 A of output current with minimal der-
ating - no heatsink required
• Wide input voltage range: 35 - 75 V, with 100V
100ms input voltage transient capability
• Fixed frequency switching provides predictable EMI
performance
• No minimum load requirement means no preload resis-
tors required
Mechanical Features
• Industry standard quarter-brick pin-out configuration
• Industry standard size: 1.45" x 2.3" (36.8x58.4mm)
• Total height less than 0.45" (11.4mm), permits better
airflow and smaller card pitch
• Total weight: 1.5 oz (42 g)
• Flanged pins designed to permit surface mount solder-
ing (avoid wave solder) using FPiP technique
Control Features
• On/Off control referenced to input side (positive and
negative logic options are available)
• Remote sense for the output voltage compensates for
output distribution drops
• Output voltage trim permits custom voltages and volt-
age margining
Protection Features
• Input under-voltage lockout disables converter at low
input voltage conditions
• Output current limit and short circuit protection protects
converter and load from damage and consequent haz-
ardous conditions
• Active back bias limit prevents damage to converter
from external load induced pre-bias
• Output over-voltage protection protects load from dam-
aging voltages
• Thermal shutdown protects converter from abnormal
environmental conditions
Safety Features
• 2000V, 30 MW input-to-output isolation provides
input/output ground separation
• UL/cUL 60950 recognized (US & Canada), basic insu-
lation rating
• TUV certified to EN60950
• Meets 72/23/EEC and 93/68/EEC directives which
facilitates CE Marking in user’s end product
• Board and plastic components meet UL94V-0 flamma-
bility requirements
Product # PQ60018QPA60
Phone [phone]
www.synqor.com
Doc.# 005-2QP618F Rev. B
09/24/08
Page 1