PQ60015HPAA0 Datasheet, PDF (1/13 Pages) SynQor Worldwide Headquarters – Half-brick DC/DC Converter

Technical
Specification
PQ60015HPAA0
48Vin 1.5Vout 100Amp 2000Vdc
Input
Output
Current
Isolation
The PQ60015HPAA0 PowerQor^® Peta half-brick converter
is a next-generation, board-mountable, isolated, fixed
switching frequency DC/DC converter that uses synchro-
nous rectification to achieve extremely high conversion
efficiency. The power dissipated by the converter is so low
that a heatsink is not required, which saves cost, weight,
height, and application effort. All of the power and control
components are mounted to the multi-layer PCB substrate
with high-yield surface mount technology for maximum reli-
ability. The Peta series converters offer industry leading
output current for a standard “half-brick” module. The Peta
units also feature active current sharing for N+1 and paral-
lel applications. RoHS compliant (see page 13).
Half-brick
DC/DC Converter
Operational Features
• Ultra-high efficiency, >89% half load, >83% full load
• Delivers up to 100 amps of output current with minimal
derating - no heatsink required
• Wide input voltage range: 35 – 75V, with 100V 100ms
input voltage transient capability
• Fixed frequency switching provides predictable
EMI performance
Mechanical Features
• Industry standard pin-out configuration
• Industry standard size: 2.3” x 2.4” (58.4 x 61.0mm)
• Total height only 0.43” (10.8mm), permits better airflow
and smaller card pitch
• Total weight: 2.9 oz. (83 grams)
Safety Features
PQ60015HPAA0 Module
Protection Features
• Input under-voltage lockout disables converter at low input
voltage conditions
• Output current limit and short circuit protection>
• Active back bias limit prevents damage to converter from
external load induced pre-bias
• Output over-voltage protection
• Thermal shutdown
Control Features
• On/Off control referenced to input side (positive and
negative logic options are available)
• Remote sense for the output voltage compensates for
output distribution drops
• Output voltage trim permits custom voltages and
voltage margining
• 2000 V, 30MΩ input-to-output isolation
• UL 60950-1:2003
• CAN/CSA-C22.2 No. 60950-1:2003
• EN60950-1:2001
• RoHS compliant (see page 13)
Optional Features
• Active current share for N+1 and parallel applications
• External Clock Synchronization pin for better
EMI characteristics
• Startup Synchronization pin for more consistent
start-up sequence
Product # PQ60015HPAA0
Phone [phone]
www.synqor.com
Doc.# 005-2HP651K Rev. D 05\20\09
Page 1