PQ40150QGX07 Datasheet, PDF (1/16 Pages) SynQor Worldwide Headquarters – Output over-voltage protection protects load from damaging voltages

18-75V
Continuous Input
15V
Outputs
Technical
Specification
PQ40150QGx07
6.67A
Current
100W 2000V dc Quarter-brick
Max Power
Isolation
DC-DC Converter
The PQ40150QGx07 PowerQor Giga quarter-brick
converter is a next-generation, board-mountable, isolated,
fixed switching frequency DC/DC converter that uses
synchronous rectification to achieve extremely high
conversion efficiency. The power dissipated by the converter
is so low that a heatsink is not required, which saves cost,
weight, height, and application effort. All of the power and
control components are mounted to the multi-layer PCB
substrate with highyield surface mount technology for
greater reliability. The PQ40 module offers a wide input
voltage range to cover both 24V and 48V applications.
RoHS compliant, see last page.
Operational Features
• High efficiency, >90% at full rated load current
• Delivers up to 6.67A of output current with minimal derating
- no heatsink required
• Ultra wide input voltage range: 18V – 75V, with 100V
100ms input voltage transient capability
• Fixed frequency switching provides predictable EMI performance
• No minimum load requirement means no preload resistors required.
Mechanical Features
• Industry standard pin-out configuration
• Standard Size:2.30"x1.45"x0.397" (58.4x36.8x10.08mm)
• Weight: 1.32 oz. (37.5 grams)
• Flanged pins designed to permit surface mount soldering,
avoid wave solder using FPiP technique on open frame units
PQ40150QGx07 Module
Protection Features
• Input under-voltage lockout disables converter at low input voltage
• Output current limit and short circuit protection protects converter
from excessive load current or short circuits
• Active back bias limit prevents damage to converter from external
load induced pre-bias
• Output over-voltage protection protects load from damaging voltages
• Thermal shutdown protectsconverer from abnormal
environmental conditions
Safety Features
• UL 60950-1:2007
• CAN/CSA-C22.2 No. 60950-1:2007
• EN60950-1/A12:2011
Control Features
• On/Off control referenced to input side
(positive and negative logic options are available)
• Remote sense for the output voltage compensates for output
distribution drops
• Output voltage trim permits custom voltages and voltage margining
Contents
Page No.
Mechanical Diagrams. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Electrical Characteristics. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Figures. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Application Section . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Ordering Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Product # PQ40150QGx07
Phone [phone]
www.synqor.com
Doc.# 005-2QG157D Rev. C 11/27/12
Page 1