|
PQ24050QGA20 Datasheet, PDF (1/13 Pages) SynQor Worldwide Headquarters – Quarter-brick DC/DC Converter | |||
|
Technical
Specification
PQ24050QGA20
24Vin
Input
5Vout
Output
20Amp 2000Vdc
Current
Isolation
Quarter-brick
DC/DC Converter
The PQ24050QGA20 PowerQor⢠Giga quarter-brick con-
verter is a next-generation, board-mountable, isolated, fixed
switching frequency DC/DC converter that uses synchronous
rectification to achieve extremely high conversion efficiency.
The power dissipated by the converter is so low that a
heatsink is not required, which saves cost, weight, height,
and application effort. All of the power and control compo-
nents are mounted to the multi-layer PCB substrate with high-
yield surface mount technology. Since the PowerQor⢠con-
verter has no explicit thermal interfaces, it is extremely reli-
able. RoHS compliant (see page 12).
Operational Features
⢠Ultra-high efficiency, 87% at full rated load current
⢠Delivers up to 20 amps of output current (100 Watts)
with minimal derating
⢠Wide input voltage range: 18V â 36V meets or
exceeds all 24V bus standards
⢠Fixed frequency switching provides predictable EMI per-
formance
⢠No minimum load requirement means no preload resis-
tors required
Mechanical Features
⢠Industry standard quarter-brick pin-out configuration
⢠Industry standard size: 1.45â x 2.3â (36.8x58.4mm)
⢠Total height less than 0.40â (10.2mm), permits better
airflow and smaller card pitch
⢠Total weight: 1.2 oz. (34 grams)
⢠Flanged pins designed to permit surface mount solder-
ing (to avoid wave solder) using FPiP technique
Control Features
⢠On/Off control referenced to input side (positive and
negative logic options are available)
⢠Remote sense for the output voltage compensates for
output distribution drops
⢠Output voltage trim permits custom voltages and voltage
margining
PQ24050QGA20 Module
Protection Features
⢠Input under-voltage lockout disables converter at low
input voltage conditions
⢠Output current limit and short circuit protection protects
converter and load from damage
⢠Active back bias limit prevents damage to converter
from external load induced pre-bias
⢠Output over-voltage protection
⢠Thermal shutdown
Safety Features
⢠2000V, 30 M⦠input-to-output isolation
⢠UL/cUL 60950-1 recognized (US & Canada), basic
insulation rating
⢠TUV certified to EN60950-1
⢠Meets 72/23/EEC and 93/68/EEC directives
⢠Meets UL94V-0 flammability requirements
⢠NEBS and ETSI compliant
Product # PQ24050QGA20
Phone 1-888-567-9596
www.synqor.com
Doc.# 005-2QG250D Rev. C 03/13/06
Page 1
|
▷ |