NQ60X60QGC20 Datasheet, PDF (1/9 Pages) SynQor Worldwide Headquarters – Quarter-brick DC-DC Converter

Technical
Specification
NQ60x60QGC20
9-60 V
Continuous Input
0-60 V
Outputs
20 A
Current
Non-
Isolated
Quarter-brick
DC-DC Converter
The NiQor^® quarter-brick dc-dc converter is a non‑isolated
buck-boost regulator, which employs synchronous rectification
to achieve extremely high conversion efficiency. The High
Input Voltage NiQor Brick family of converters can be used
in traditional DPA (distributed power architecture) systems
or provide a regulated output voltage from a battery source
or other variable voltage source. The NiQor Brick family
can be configured to Buck the input voltage down to a
lower voltage or Boost the input voltage up to a higher
voltage using a single external resistor. These modules are
RoHS 6/6 compliant (see last page).
Non-Isolated
Operational Features
• Ultra high efficiency, up to 95% at full rated load
• Delivers up to 20 A of output current
• Input Voltage Range: 9 - 60 V
• Output voltage range: 0 - 60 V (negative output is possible)
• Extensive on-board input and output filtering
• No minimum load requirement means no preload
resistors required
• Buck or buck-boost mode available
• Adjustable current limit with current monitor (C option)
Mechanical Features
• Industry standard quarter-brick pin-out configuration
• Size: 1.54" x 2.39" (39x60.6 mm)
• Total height only 0.515" (13.08 mm)
• Total weight: 3 oz (85 g)
Control Features
• On/Off control
• Output voltage trim permits custom voltages
• Remote Sense (S option, standard)
• Current limit trim (C option)
NiQor quarter-brick module
Protection Features
• Input under-voltage lockout protects the converter at low
input voltage conditions
• Over-current shutdown protects converter from excessive
load current or short circuits
• Output over-voltage protection protects load from
damaging voltages
• Thermal shutdown protects converter from abnormal
environmental conditions
Safety Features
• UL/cUL 60950-1 recognized (US & Canada)
• TUV certified to EN60950-1
• Board and plastic components meet UL94V-0
flammability requirements
Product # NQ60x60QGC20
Phone [phone]
www.synqor.com
Doc.# 005-NQ6060W Rev. B 03/16/09
Page 1