|
NQ12T50SMA16 Datasheet, PDF (1/15 Pages) SynQor Worldwide Headquarters – 16A Non-Isolated, SMT DC/DC Converter with wide trim | |||
|
Technical Specification
Non-Isolated
SMT Converter
9.6 - 14.4Vin 16A
16A Non-Isolated, SMT DC/DC Converter with wide trim
The NiQor⢠SMT DC/DC converter is a non-isolat-
ed buck regulator, which employs synchronous rec-
tification to achieve extremely high conversion effi-
ciency. The NiQor family of converters are used
predominately in DPA systems using a front end
DC/DC high power brick (48Vin to low voltage bus).
The non-isolated NiQor converters are then used at
the point of load to create the low voltage outputs
required by the design. The wide trim module can
be programmed to a variety of output voltages
through the use of a single external resistor.
Non-Isolated
NQ12T50SMA16 wide trim module
Operational Features
⢠Ultra-high efficiency, up to 95% at full and half load
⢠Delivers 16 amps of output current with minimal der-
ating - no heatsink required
⢠Input voltage range: 9.6 - 14.4V
⢠Programmable output voltages from 0.85 - 5.0V
⢠On-board input and output filter capacitor
⢠No minimum load requirement means no preload
resistors required
Protection Features
⢠Input under-voltage lockout disables converter at
low input voltage conditions
⢠Temperature compensated over-current shutdown
protects converter from excessive load current or
short circuits
⢠Output over-voltage protection protects load from
damaging voltages
⢠Thermal shutdown
Product # NQ12T50SMA16
Phone 1-888-567-9596
Mechanical Features
⢠Industry standard SMT pin-out configuration
⢠Industry standard size: 1.3â x 0.53â x 0.29â (33 x
13.5 x 7.3 mm)
⢠Total weight: 0.18 oz. (5 grams), lower mass greatly
reduces vibration and shock problems
⢠Open frame construction maximizes air flow cooling
⢠Also available in SIP packaging
Control Features
⢠On/Off control
⢠Remote sense
⢠Output voltage trim (industry standard) permits cus-
tom voltages and voltage margining
⢠Fixed output voltage modules available (0.9 - 5.0V)
Safety Features
⢠UL 1950 recognized (US & Canada)
⢠TUV certified to EN60950
⢠Meets 72/23/EEC and 93/68/EEC directives
which facilitates CE Marking in userâs end product
⢠Board and plastic components meet UL94V-0 flam-
mability requirements
Doc.# 005-2NS12TE Rev. A
5/28/04
Page 1
|
▷ |