|
NQ04009VMA15NRS Datasheet, PDF (1/20 Pages) SynQor Worldwide Headquarters – 16Amp, wide ouput range, Non-Isolated DC/DC Converter | |||
|
Technical Specification *
Non-Isolated
SIP Converter
3.0 - 5.5Vin 16A
16Amp, wide ouput range, Non-Isolated DC/DC Converter
The NiQor⢠SIP DC/DC converter is a non-isolated
buck regulator, which employs a fixed switching fre-
quency and synchronous rectification to achieve
extremely high conversion efficiency. The NiQor
family of converters are used predominately in DPA
systems using a front end DC/DC high power brick
(48Vin to low voltage bus). The non-isolated NiQor
converters are then used at the point of load to cre-
ate the low voltage outputs required by the design.
The wide trim module can be programmed to a vari-
ety of output voltages through the use of a single
resistor.
Non-Isolated
NiQor vertical mount SIP module
Operational Features
⢠Ultra-high efficiency, up to 94% full load, 95% half
⢠Delivers 16 amps of output current with minimal der-
ating - no heatsink required
⢠Input voltage range: 3.0 - 5.5V
⢠Programmable output voltages from 0.85 - 3.6V
⢠Fixed frequency switching provides predictable EMI
performance
⢠Fast transient response time
⢠On-board input and output filter capacitor
⢠No minimum load requirement means no preload
resistors required
Protection Features
⢠Input under-voltage lockout disables converter at
low input voltage conditions
⢠Temperature compensated over-current shutdown
protects converter from excessive load current or
short circuits
⢠Output over-voltage protection protects load from
damaging voltages (>4.4V)
⢠Thermal shutdown
* Final datasheet pending ECO review and signature.
Product # NQ04T33VMA16
Phone 1-888-567-9596
Mechanical Features
⢠Industry standard SIP pin-out configuration
â¢Industry standard size: 2.0â x 0.55â x 0.29 (50.8 x
14 x 7.3mm)
⢠Total weight: 0.30 oz. (9.4 g), lower mass greatly
reduces vibration and shock problems
⢠Open frame construction maximizes air flow cooling
⢠Available in both vertical and horizontal mounting
Control Features
⢠On/Off control
⢠Output voltage trim (industry standard) permits
custom voltages and voltage margining
⢠Remote sense (standard option)
⢠Fixed output voltage 15A modules available
(0.9V - 3.3V)
Safety Features
⢠UL 1950 recognized (US & Canada)
⢠TUV certified to EN60950
⢠Meets 72/23/EEC and 93/68/EEC directives
which facilitates CE Marking in userâs end product
⢠Board and plastic components meet UL94V-0 flam-
mability requirements
Doc.# 005-2NV4T3E Rev. B
7/6/04
Page 1
|
▷ |